Canon VIXIA HF R11 VIXIA HF R10/HF R11/HF R100 Instruction Manual - Page 43

• In mode, you can also set [Zoom Speed] to one of three constant speeds (3 is the fastest, 1 the slowest). • When [Zoom Speed] is set to [ Variable], the zoom speed will be faster in record pause mode than when actually recording, except when pre-recording ( 59) is activated. Quick Start Function When you close the LCD panel with the camcorder on, the camcorder enters the standby mode. In standby mode the camcorder consumes only about 1/3 the power used when recording, saving energy when you are using a battery pack. Additionally, when you open the LCD panel, the camcorder is ready to start recording in approximately 1 second*, allowing you to record the subject right away. * The actual time required varies depending on the shooting conditions. Operating modes: 1 With the camcorder on and in a recording mode, close the LCD panel. A beep will sound and the green ON/OFF (CHG) indicator will change to orange to indicate the camcorder entered standby mode. 2 When you wish to resume recording, open the LCD panel. The ON/OFF (CHG) indicator turns back green and the camcorder is ready to record. IMPORTANT • Do not disconnect the power source during standby mode (while the ON/OFF (CHG) indicator is lit in orange). NOTES • The camcorder will not enter standby mode if the LCD panel is closed while the ACCESS indicator is on or flashing, while a menu is being displayed, or while the PHOTO button is pressed down halfway. The camcorder may also not enter standby mode if the LCD panel is closed while the memory card slot cover is open or when the battery charge is too low. Check that the ON/OFF (CHG) indicator changes to orange. Video Š 43