Canon VIXIA HF R32 VIXIA HF R30 / HF R32 / HF R300 Instruction Manual - Page 195

&/% Built-in memory is full - The built-in memory is full ("& End" appears on the screen). Delete some recordings (A 60, 120) to free some space. Alternatively, save your recordings (A 131) and initialize the built-in memory (A 42). &/% Built-in memory writing error Attempt to recover the data? - This message will appear the next time you turn on the camcorder if power supply was accidentally interrupted while the camcorder was writing to the built-in memory. Select [Recover] to try to recover the recordings. &/% Cannot access the built-in memory - There is a problem with the built-in memory. Contact a Canon Service Center. Cannot communicate with the battery pack. Continue using this battery pack? - You attached a battery pack that is not recommended by Canon for use with this camcorder. - If you are using a battery pack recommended by Canon for use with this camcorder, there may be a problem with the camcorder or battery pack. Consult a Canon Service Center. &/% Cannot convert - Cannot access the memory card. Check the memory card and make sure it is inserted cor- rectly. - You inserted a MultiMedia Card (MMC) into the camcorder. Use a recommended memory card (A 37). - There was an error creating the file name. Set > [File Numbering] to [Reset] and initialize the memory card (A 42) or delete all the photos (A 120) and converted SD mov- ies (A 60). Cannot copy - The total size of the scenes you selected to copy exceeds the available space on the memory card. Delete some recordings on the memory card (A 60, 120) or reduce the number of scenes to copy. - The memory card already contains the maximum number of AVCHD scenes (3,999 scenes). Delete some scenes (A 60) to free some space. - The gallery already contains the maximum number of stories (98 stories in any one given memory). Delete some stories (A 63) to free some space. Cannot divide the scene. Initialize only using the camcorder. - The scene could not be divided because the camcorder's internal scene management data log is full. Save your recordings (A 131) and initialize the memory (A 42). Transfer back the backup files and try dividing the scene again. - &/% Use the supplied software VideoBrowser to save the scene and divide it on the computer. Cannot enter standby mode now - The camcorder cannot enter standby mode if the remaining battery charge is too low. Charge or replace the battery pack (A 20). Additional Information Š 195