Canon iPF710 iPF710 User Manual - Page 124

Handling rolls Loading the Roll in the Printer Follow these steps to load rolls in the printer. Note • Remove any loaded paper that will not be used. • Roll (→P.113) (→P.114) • Sheet (→P.139) • If the Platen is dirty, clean inside the Top Cover. (→P.589) 1. Push the Release Lever back and pull out the roll paper evenly on both ends. Insert the edge in the Paper Feed Slot (a) and advance the paper until vacuuming paper starts. After the paper reaches the Platen, it is automatically advanced and vacuuming paper starts. Important • Be careful not to soil the printing surface of roll paper as you insert it in the slot. This may affect the printing quality. We recommend wearing clean cloth gloves when handling rolls to protect the printing surface. • If the paper is wrinkled or warped, straighten it out before loading it. • If it is difcult to insert the roll paper in the Paper Feed Slot, insert the left or right corner in the slot rst, and then straighten the paper as you advance it. • Load the roll so that there is no gap between the right edge of the paper and the Roll Holder. Note • You can adjust the strength of vacuum holding paper against the Platen when the Release Lever is open. If it is difcult to load paper, press the ▲ or ▼ button on the Control Panel to adjust the strength. Set vacuum stronger by pressing the ▲ button or weaker with the ▼ button. Three settings are available. 110 Handling Paper