Canon iPF710 iPF710 User Manual - Page 622

The printer stops during a print job The printer stops during a print job An error message is shown on the Display Screen Status An error message is displayed during printing. Corrective Action Check the error message and take action as necessary. (→P.629) The last portion of roll paper was used during a print job, and paper could not be advanced because the trailing edge is taped to the roll. Remove the used roll and insert a new roll. (→P.113) (→P.114) (→P.115) (→P.77) The printer ejects blank, unprinted paper Status The leading edge of the roll paper was cut to straighten it. Corrective Action This operation is normal. The printer cuts the leading edge of the roll to straighten it and ejects the scraps when Trim Edge First in the printer menu is On or when Trim Edge First is Automatic and the leading edge is slanted. The printer is ready to print after this initial preparation. When Off is selected under Trim Edge First, the edge is not cut and scraps are not removed. The Printhead nozzles are clogged. Print a test pattern to check the nozzles and make sure the Printhead is in good condition for printing. (→P.567) Clean the Printhead if the nozzles are clogged. (→P.568) A print job was received from an incompatible printer Use the correct imagePROGRAF printer driver for driver. the printer and try printing again. The printer has received print data that includes HP RTL commands when Auto Rotate is On. Set Auto Rotate to Off before attempting to print again. (→P.48) The printer is damaged. Contact your Canon dealer for assistance. The printer stops when printing a HP-GL/2 job (the carriage stops moving) Cause The printer is analyzing the print job. Corrective Action Either wait a while for printing to resume, or on the printer Control Panel, set Input Resolution to 300dpi. (→P.48) 608 Troubleshooting