Canon iPF710 iPF710 User Manual - Page 650
Leading edge detection error., Cannot feed paper., Cannot cut this paper., End of paper feed., Rel
UPC - 013803085822
View all Canon iPF710 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 650 highlights
Messages regarding paper Leading edge detection error. Cause A roll has been loaded when sheets are selected as the paper source on the Control Panel. Corrective Action Either remove the roll and load a sheet or select the roll as the media source on the Control Panel. The sheet is loaded askew. Reload the sheet straight, in the correct position. (→P.135) Cannot feed paper. Cause Paper came out of the feed path during feeding. Corrective Action Reload the paper correctly and advance it again. (→P.110) If the message is displayed when paper is not being advanced, contact your Canon dealer for assistance. Cannot cut this paper. Cause There are sheets left on the Ejection Guide. Corrective Action Remove the paper. There is a foreign object by the Output Tray, obstructing the Cutter Unit. Remove the foreign object. You are not using the printer under the recommended Use the printer only where the recommended environmental conditions for the paper. environmental conditions for the paper are met. Note that various environmental conditions are recommended for various types of paper. For details on the recommended environmental conditions for paper, see "Types of Paper". (→P.95) You are using paper that is not compatible with automatic cutting. Cut the roll manually. (→P.124) The Cutter Unit stops in the middle of cutting. Move the Carriage to the left, remove the paper, and return the Carriage to the right. If the roll cannot be cut using the Cutter Unit, cut the roll manually. (→P.116) (→P.124) The Cutter Unit is not installed. Install the Cutter Unit. (→P.577) In other cases, the Cutter Unit may be damaged. Contact your Canon dealer for assistance. End of paper feed. Cause You are pressing the ▲ button on the Control Panel and trying to rewind the roll to the edge. Corrective Action Release the ▲ button. Rel lever is in wrong position. Cause The Release Lever is pushed back. Corrective Action Pull the Release Lever forward. 636 Error Message