Canon imageCLASS D1150 imageCLASS D1180/D1170/D1150/D1120 Basic Operation Guid - Page 155
Sending Documents to More Than One Location (Broadcasting), Repeat step 4 to enter all required
View all Canon imageCLASS D1150 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 155 highlights
Specifying Destinations Sending Documents to More Than One Location (Broadcasting) Broadcasting enables you to send the same document to multiple recipients. - A maximum of 201 destinations can be specified at the same time. (Out of the 200 destinations, a number or address can be specified with - , [numeric keys] and [Tone].) If you specify a group, which is made up of several destinations, each destination in the group is counted as a separate address. - If you frequently send documents to multiple destinations, it is recommended that you store those destinations as a group. - If in in is set to , you cannot send the documents to multiple recipients. (See "Restricting Broadcasting," in the e-Manual.) 1 Place documents. Ex. FAX NUMBER TEL=012XXXXXXX Use - , [numeric keys] and [Tone], one-touch keys, coded dial codes, or [Address Book] to specify destinations. - Only one destination can be specified using - , [numeric keys] and [Tone]. Make sure to press [OK] after entering the recipient's number. - If in in is set to and you specify a fax number using - , [numeric keys] and [Tone], you must enter the fax number again for confirmation. Enter the same fax number you entered in step 4, then press [OK]. 5 Repeat step 4 to enter all required recipients. Fax (D1180/D1170/D1150) 2 Press [SEND/FAX]/ [FAX]. 3 Press [SEND/FAX] repeatedly to select , then press [OK]. FAX SELECT:OK For the D1150, skip this step. 4 Specify the destination. 6-24 - To check all the specified destinations, press or to scroll the display. - To cancel all the specified destinations, press [Stop/Reset]. 6 Press [Start]. When you place the documents on the platen glass, press or to select the document size, then press [Start] for each document. When scanning is complete, press [OK] to start sending. When is set to in in in , and if you have specified the destination by any other method than using - , [numeric keys] and [Tone], the machine starts scanning automatically without pressing [Start], after the preset time for this setting is elapsed. (See "Time Out Mode," on p. 6-41.)