Canon imageCLASS MF4570dn Wireless Setup Guide

Canon imageCLASS MF4570dn Manual

Canon imageCLASS MF4570dn manual content summary:

  • Canon imageCLASS MF4570dn | Wireless Setup Guide - Page 1
    P.1-1 Troubleshooting ʁ P.2-1 Starter Guide For procedures other than printer installation and wireless LAN setup, please refer to the [Starter Guide]. Read this guide before setting up the wireless LAN This guide describes the wireless LAN setup procedure and problems encountered
  • Canon imageCLASS MF4570dn | Wireless Setup Guide - Page 2
    's home page If you are looking to install your new device via a Wireless Network connection, you can find a video and written guides with step-by-step instructions to assist you through the process from Canon's home page. You can access Canon's home page by following the procedures shown below
  • Canon imageCLASS MF4570dn | Wireless Setup Guide - Page 3
    be able to use the machine on the wireless LAN network even if you perform the following steps. For more information, see the instruction manual for the network device you are using, or contact the networking device manufacturer. Internet Required Environment Wireless LAN router or access point
  • Canon imageCLASS MF4570dn | Wireless Setup Guide - Page 4
    Press [ ] or [ ] to select, and press [OK]. Network Settings Select Wired/Wireles Wireless LAN Settin... TCP/IP Settings SNMP Settings Wait for 10 seconds at least ON ON OFF OFF When the connection method has been changed, proceed to "Step3 Selecting a Method for Setting the Wireless LAN" on
  • Canon imageCLASS MF4570dn | Wireless Setup Guide - Page 5
    LAN or access point, connecting using WPS (Wi-Fi Protected Setup) function or connecting manually. No Is there a WPS button? • For checking whether it supports the WPS, find the descriptions such as "... supports WPS..." or shown on the wireless LAN router/access point or its package. • For
  • Canon imageCLASS MF4570dn | Wireless Setup Guide - Page 6
    Wireless LAN Setting Guide to perform settings. OK 8. Within 2 minutes, press and hold the WPS button on the wireless LAN router or access point. * The amount of time you must hold down the WPS button will depend on the model you are using. Please refer to the instruction manual for your wireless
  • Canon imageCLASS MF4570dn | Wireless Setup Guide - Page 7
    close the screen, and repeat from procedure 6. If the access point cannot be detected even after retrying, see the following. Proceed to "When an Error Message Appears," on P.2-2. The wireless LAN setting is completed. Next, install the software. For details, please refer the "Starter Guide". 1-5
  • Canon imageCLASS MF4570dn | Wireless Setup Guide - Page 8
    network key using "Canon MF/LBP Wireless Setup Assistant" in the User Software CD-ROM that manufacturer. 6. Press [OK]. See Wireless LAN Setting Guide to perform settings. OK 7. Press [ ] press [OK]. SSID Settings Select Access Point Manual Settings The next screen is displayed for approximately
  • Canon imageCLASS MF4570dn | Wireless Setup Guide - Page 9
    matched SSIDs are displayed, select the ID that is listed first (the one with the strongest signal). Select Access Point SampleABCD WEP 13 SampleEFGHIJ WPA step 11. Entry Format 5 Char. (40bit ASCII) 13 Char. (104bit ASC... 10 Digits (40bit Hex) 26 Digits (104bit Hex) 11. Enter the network key that
  • Canon imageCLASS MF4570dn | Wireless Setup Guide - Page 10
    for approximately 2 seconds, and the Wi-Fi indicator will start blinking. Connected. If an Error Message Appears Press [OK] to close the screen, check if the network key is correct The wireless LAN setting is completed. Next, install the software. For details, please refer the "Starter Guide". 1-8
  • Canon imageCLASS MF4570dn | Wireless Setup Guide - Page 11
    Troubleshooting Troubleshooting This section describes the causes and solutions for the problems occurred during wireless LAN settings. To set and operate the wireless LAN router or access points Please read the instruction manual for the wireless LAN router or access point, or contact the
  • Canon imageCLASS MF4570dn | Wireless Setup Guide - Page 12
    Troubleshooting When an Error manually selecting an access point $BVTF The machine cannot detect the wireless LAN routers or access points because there is a problem using supports the WPS function. ( Proceed to "Selecting a Method for Setting the Wireless LAN," on P.1-3.) [If it is supported]
  • Canon imageCLASS MF4570dn | Wireless Setup Guide - Page 13
    Troubleshooting "Wireless connection failed." $BVTF 4PMVUJPO An error occurred on the machine while specifying the "Shared Key" set for the wireless LAN router or access point you are using. Manually set the authentication method of this machine to according to the wireless LAN
  • Canon imageCLASS MF4570dn | Wireless Setup Guide - Page 14
    Troubleshooting If Problems Occur The SSID of the wireless LAN router or access point is not "Step4-B Setting the Access Point Manually and Connecting," on P.1-6. The machine cannot detect the wireless LAN routers or access points because there is a problem with the network connection. Check the
  • Canon imageCLASS MF4570dn | Wireless Setup Guide - Page 15
    Troubleshooting The Remote UI is not displayed. $BVTF 4PMVUJPO $BVTF 4PMVUJPO Machine Using the WPS (Push Button Mode)," on P.1-4. Proceed to "Step4-B Setting the Access Point Manually and Connecting," on P.1-6. The wireless LAN routers or access point network key is not correctly specified
  • Canon imageCLASS MF4570dn | Wireless Setup Guide - Page 16
    Troubleshooting Turn the power OFF and turn it back ON.  Check if the installation sites for the machine, the wireless LAN router, or access point meet the Mode)," on P.1-4. Proceed to "Step4-B Setting the Access Point Manually and Connecting," on P.1-6. Refer below if you cannot connect the machine
  • Canon imageCLASS MF4570dn | Wireless Setup Guide - Page 17
    of the wireless LAN routers or access points The MAC address filtering is enabled. An encryption method only when communicating using IEEE802.11n: TKIP To set and operate the wireless LAN router or access points Please read the instruction manual for the wireless LAN router or access point, or
  • Canon imageCLASS MF4570dn | Wireless Setup Guide - Page 18
    Completed 1. Press [ ] (Status Monitor/Cancel). 2. Select with [ ] and [ ], and then press [OK]. Status Monitor/Cancel TX Job RX Job Fax Forwarding Erro... Network Information 3. Select with [ ] and [ ], and then press [OK]. Network Information IPv4 IPv6 Wireless LAN Informa... 4. Select with
  • Canon imageCLASS MF4570dn | Wireless Setup Guide - Page 19
    following Canon Web site: www.usa.canon.com 1. Insert the User Software CD-ROM into the CD slot on your computer. 2. Click [Additional Software to Step 8 in "Setting the Access Point Manually and Connecting" (P.1-6). 3. Select the SSID that matches the one you wrote down from the displayed SSID in
  • Canon imageCLASS MF4570dn | Wireless Setup Guide - Page 20
    MARKETING JAPAN INC. 16-6, Konan 2-chome, Minato-ku, Tokyo 108-8011, Japan CANON U.S.A., INC. One Canon Plaza, Lake Success, NY 11042, U.S.A. CANON EUROPA N.V. Bovenkerkerweg, 59-61, 1185 XB Amstelveen, The Netherlands CANON CHINA CO. LTD. 15F Jinbao Building No.89, Jinbao Street, Dongcheng District
  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20

Read this guide before setting up the wireless LAN
This guide describes the wireless LAN setup procedure and
problems encountered during the configuration.
After you finish reading this guide, store it in a safe place for
future reference.
Starter Guide
Troubleshooting
XXXXXXXXX
P.2-1
P.1-1
W
ireless LAN Setting Guide
For procedures other
than printer installation
and wireless LAN setup,
please refer to the
[Starter Guide].
Setting the
wireless LAN