Canon imageFORMULA CR-50 CR-50/80 Operation & Maintenance Guide
Canon imageFORMULA CR-50 Manual
View all Canon imageFORMULA CR-50 manuals
Add to My Manuals
Save this manual to your list of manuals |
Canon imageFORMULA CR-50 manual content summary:
- Canon imageFORMULA CR-50 | CR-50/80 Operation & Maintenance Guide - Page 1
Operation & Maintenance Guide ♦ Please read this manual before operating this scanner. - Canon imageFORMULA CR-50 | CR-50/80 Operation & Maintenance Guide - Page 2
instructions, manual. If such changes or modifications should be made, you could be required to stop operation of the equipment. Canon U.S.A. Inc. One Canon service. For more information regarding return and recycling of WEEE products, please visit www.canon CR-50: Model M111101 CR-80: Model M111102 2 - Canon imageFORMULA CR-50 | CR-50/80 Operation & Maintenance Guide - Page 3
also be trademarks or registered trademarks in other countries. • imageFORMULA is a trademark of CANON ELECTRONICS INC. • Microsoft, Windows, Windows XP, Windows THE MAXIMUM LIABILITY OF CANON ELECTRONICS INC. UNDER THIS WARRANTY IS LIMITED TO THE PURCHASE PRICE OF THE PRODUCT COVERED BY THE WARRANTY. - Canon imageFORMULA CR-50 | CR-50/80 Operation & Maintenance Guide - Page 4
up the CR-50/80 in accordance with the Installation Guide. For details on the CR-50/80, refer to the Instructions (electronic manual). Operation & Maintenance Guide (Supplied with the scanner/ Electronic Manual): This Manual Describes the basic operations for using the CR-50/80, troubleshooting, and - Canon imageFORMULA CR-50 | CR-50/80 Operation & Maintenance Guide - Page 5
Table of Contents INTRODUCTION 4 Manuals for the CR-50/80 4 Symbols Used in This Manual 4 Document Feeding and Scanning 6 Documents 6 Document 6 Placing Documents 7 Document Feeding and Scanning 7 Scan Procedure 7 Troubleshooting 9 When the Scanner Is Not Recognized 9 Clearing Paper Jams - Canon imageFORMULA CR-50 | CR-50/80 Operation & Maintenance Guide - Page 6
paper edges may cut your fingers. Document The CR-50/80 can feed a wide variety of document sizes. The ranges of height and length be sure to clean the scanning rollers. (See "Cleaning the Scanning Glass and Rollers" on p. 13.) • If you scan thin paper in the Duplex mode, the ink printed on the - Canon imageFORMULA CR-50 | CR-50/80 Operation & Maintenance Guide - Page 7
Placing Documents Note the following points when placing documents on the scanner. • Place the front of the document toward you. • A maximum of 50 documents or a document stack no higher than 5 mm (0.2") can be loaded at one time. • Move the stopper to the edge of the document in the - Canon imageFORMULA CR-50 | CR-50/80 Operation & Maintenance Guide - Page 8
When Using the Accompanying Scanning Utility for CR-50/80: There are three scanning methods as follows. Follow the each instruction. Scan 1 page Click [Scan Page] Scanning starts. NOTE When printing with the imprinter, ink may get on the leading edge of the document because the documents are ejected - Canon imageFORMULA CR-50 | CR-50/80 Operation & Maintenance Guide - Page 9
Troubleshooting This chapter describes the problems that might occur in the CR-50/80, and how to remedy them. When guaranteed. Contact your local authorized Canon dealer for more detailed information. (See "Checking Your Operating Environment," on p. 18 in Instructions.) USB cable is not compatible - Canon imageFORMULA CR-50 | CR-50/80 Operation & Maintenance Guide - Page 10
2 While lowering the down the OPEN lever, open the reading unit. If the paper is jammed at any other area: Pull the paper forward and clear the jam from the nearest opening. 3 Remove the paper that has jammed. If the paper is jammed at the pickup area: Pull the paper forward and clear the jam from - Canon imageFORMULA CR-50 | CR-50/80 Operation & Maintenance Guide - Page 11
cord into a power outlet. (See "Connecting the Power Cord" on p. 14 in Installation Guide.) Feeding Trouble If the document is not fed properly or the detection functions do not work properly, remedy the problem by checking the following conditions. Condition Cause and Remedy Condition Cause and - Canon imageFORMULA CR-50 | CR-50/80 Operation & Maintenance Guide - Page 12
may also be the problem. The imprinter is not printing correctly (missing imprint dots). Ink is clogged in the ink jet nozzle. Clean the ink jet nozzle. Cleaning the ink jet nozzle is recommended before using the CR-50/80. (See "Cleaning the Ink Jet Nozzles" on p. 16.) The ink cartridge may be empty - Canon imageFORMULA CR-50 | CR-50/80 Operation & Maintenance Guide - Page 13
Maintenance This chapter describes how to clean and maintain the scanner. Daily Cleaning To ensure high-quality image scanning, regularly clean your CR-50/80 as described below. CAUTION • Before you clean the scanner, turn OFF the scanner and computer, and disconnect the power cord from the power - Canon imageFORMULA CR-50 | CR-50/80 Operation & Maintenance Guide - Page 14
ԧԥ ԣ Ԥ Ԣ ԡ Ԡ ԙԛ Ԙ Ԛ ԟ Ԝ Ԟ ԝ NOTE • Use cotton swabs to clean the rollers in locations that are too narrow for your fingers, such as a, b, j, n, o, off of the exposed area. ԧ Ԣ ԙԛ Ԝ 4 Use cotton swabs to clean the entire scanning glass. There are two scanning glass areas, one on each side - Canon imageFORMULA CR-50 | CR-50/80 Operation & Maintenance Guide - Page 15
cause feeding errors. If there are scratches on the scanning glass, contact your local authorized Canon dealer or service representative. 5 Gently close the reading unit until it clicks into place. Cleaning the Magnetic Heads If the magnetic heads are dirty, then MICR characters cannot be scanned - Canon imageFORMULA CR-50 | CR-50/80 Operation & Maintenance Guide - Page 16
out thoroughly, and then wipe off the dirt around the ink absorber. Ink Absorber IMPORTANT If your documents are stained and smudged from printing even after you clean the ink absorber, you should replace the ink absorber. Contact your local authorized Canon dealer or service representative. 16 - Canon imageFORMULA CR-50 | CR-50/80 Operation & Maintenance Guide - Page 17
appear faint after this operation, replace the ink cartridge (See "Replacing the Ink Cartridge" on p. 18.) 7 Gently close the Maintenance Cover until it clicks into place. 5 Set the ink cartridge. For more information, see "Replacing the Ink Cartridge" on p. 18. 6 Carefully replace the Imprinter - Canon imageFORMULA CR-50 | CR-50/80 Operation & Maintenance Guide - Page 18
if you have cleaned the ink jet nozzle. The ink cartridge is not included with the scanner. Purchase an ink cartridge separately, as shown below. Manufacturer : Hewlett Packard Ink Cartridge Blue : C6602B (Canon#3693A002) Ink Cartridge Red : C6602R (Canon#3693A003) Ink Cartridge Green: C6602G - Canon imageFORMULA CR-50 | CR-50/80 Operation & Maintenance Guide - Page 19
jet nozzle right after imprinting. The nozzle may be very hot. 5 Place the ink cartridge shown in the diagram below. IMPORTANT Make sure that the ink cartridge lock lever locks the ink cartridge into the correct position. CAUTION Do not touch the electrical contact on the carriage. Doing so may - Canon imageFORMULA CR-50 | CR-50/80 Operation & Maintenance Guide - Page 20
replace the Imprinter Cover. Top: 50.5 mm (1.99") from the bottom edge of the document Middle: 47 mm (1.85") from the bottom edge of the document Bottom: 43.5 mm (1.71") from the bottom edge of the document If the ink head drops back when installed, the two ink cartridge pins will not fit into - Canon imageFORMULA CR-50 | CR-50/80 Operation & Maintenance Guide - Page 21
Adjusting the Separation Roller Gap If double feed should occur too often, adjust the Separation Roller gap according to the following procedure. IMPORTANT • Make sure that the size, thickness, and weight of your document meets the conditions of this scanner. See "Documents" on p. 6. • Your unit has - Canon imageFORMULA CR-50 | CR-50/80 Operation & Maintenance Guide - Page 22
Confirm that the document feeds properly. See "Confirming Proper Document Feeding" on p. 37 in Instructions. If additional assistance is required, contact your local authorized Canon dealer or service representative. 9 Place a marking label on the unit pointing to the adjustment dial as illustrated - Canon imageFORMULA CR-50 | CR-50/80 Operation & Maintenance Guide - Page 23
6 Document 6 How to place documents 7 F Feeding Trouble 11 I Ink Cartridge 18 Ink Jet Nozzle 16 M Magnetic head 15 Maintenance 18 N Number of pages loaded 7 P Print Position Adjustment Lever 18 R Rollers 13 S Scanning Glass 13 T The Scanner Does Not Turn ON 11 Troubleshooting 9 23 - Canon imageFORMULA CR-50 | CR-50/80 Operation & Maintenance Guide - Page 24
INC. 1248, SHIMOKAGEMORI, CHICHIBU-SHI, SAITAMA 369-1892, JAPAN CANON U.S.A. INC. ONE CANON PLAZA, LAKE SUCCESS, NY 11042, U.S.A. CANON CANADA INC. 6390 DIXIE ROAD, MISSISSAUGA, ONTARIO L5T 1P7, CANADA CANON EUROPA N.V. BOVENKERKERWEG 59-61, P.O.BOX 2262, 1180 EG AMSTELVEEN, THE NETHERLANDS
♦
Please read this manual before operating this scanner.
Operation & Maintenance Guide