Casio FX-CG10 Software User Guide - Page 550
Using Setup Wizard to Con a PhotoGate Setup, On the Select Sensor screen
View all Casio FX-CG10 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 550 highlights
ε-5 Using the Setup Wizard k Using Setup Wizard to Configure a PhotoGate Setup Connection of a Vernier PhotoGate requires configuration of setup parameters that are slightly different from parameters for other types of sensors. • To configure a setup for PhotoGate alone 1. Perform the first two steps of the procedure under "To configure an EA-200 setup using Setup Wizard" on page ε-2. 2. On the "Select Sensor" screen, select [VERNIER] - [Photogate] - [Gate]. • This displays a screen where you specify whether PhotoGate is connected to the CH1 or SONIC channel. 3. Press 1 to specify CH1 or 2 to specify SONIC. • This causes a "Gate Status" screen to appear. • "Open" means the photo path is not blocked, while "Close" means the photo path is blocked. • The gate status defines what PhotoGate status should cause timing to start, and what status should cause timing to stop. Open-Open Timing starts when the gate opens, and continues until it closes and then opens again. Open-Close Timing starts when the gate opens, and continues until it closes. Close-Open Timing starts when the gate closes, and continues until it opens. Close-Close Timing starts when the gate closes, and continues until it opens and then closes again. 4. Use function keys 1 through 4 to select a Gate Status setting. • Selecting a gate status causes a screen for specifying the number of samples to appear. 5. Input an integer in the range of 1 to 255 to specify the number of samples. 6. Perform step 10 under "To configure an EA-200 setup using Setup Wizard" on page ε-2 to finalize the procedure. • To configure a setup for PhotoGate and Smart Pulley 1. Perform the first two steps of the procedure under "To configure an EA-200 setup using Setup Wizard" on page ε-2. 2. On the "Select Sensor" screen, select [VERNIER] - [Photogate] - [Pulley]. • This causes an "Input Distance(m)" screen to appear. • The distance you specify here is the distance the weight travels after it is released. • Input a value in the range of 0.1 to 4 to specify the distance in meters. 3. Perform step 10 under "To configure an EA-200 setup using Setup Wizard" on page ε-2 to finalize the procedure. 20100801