Casio FX-CG10 Software User Guide - Page 551
Outputting the Waveform of a Function through the Speaker, not change these settings.
View all Casio FX-CG10 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 551 highlights
ε-6 Using the Setup Wizard k Outputting the Waveform of a Function through the Speaker Normally, the Setup Wizard helps you configure setups for sensors connected to the EA200. If you select [CASIO] - [Speaker] - [y=f(x)] on the "Select Sensor" screen, however, it configures the EA-200 to output the sound that corresponds to a function that you input and graph on the calculator. • To configure a setup for speaker output 1. Connect the data communication cable (SB-62) to the communication port of the calculator and the MASTER port of the EA-200. 2. Perform the first two steps of the procedure under "To configure an EA-200 setup using Setup Wizard" on page ε-2. 3. On the "Select Sensor" screen, select [CASIO] - [Speaker] - [y=f(x)]. This displays a screen like the one shown nearby. 4. Press w to advance to the View Window setting screen. • The following settings are configured automatically: Ymin = -1.5 and Ymax = 1.5. Do not change these settings. 5. Press w or J to advance to the graph relation list. 6. In line "Y1", input the function of the waveform for the sound you want to input. • Note that the angle unit is always radians. • Input a function where the value of "Y" is within the range of -1.5 to +1.5. 7. Press 6(DRAW) to graph the function. • This graphs the function and displays a vertical cursor line as shown in the sample display nearby. Use the graph to specify the range that you want to output to the speaker. 8. Use the d and e cursor keys to move the cursor to the start point of the output, and then press w to register it. 20100801