Casio FX-CG10 Software User Guide - Page 552
To change the output frequency and try again, To change the function
View all Casio FX-CG10 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 552 highlights
ε-7 Using the Setup Wizard 9. Use the d and e cursor keys to move the cursor to the end point of the output, and then press w to register it. • After you specify the start point and end point, an output frequency dialog box shown below appears on the display. → 10. Input a percent value for the output frequency value you want. • To output the original sound as-is, specify 100%. To raise the original sound by one octave, input a value of 200%. To lower the original sound by one octave, input a value of 50%. 11. After inputting an output frequency value, press w. • This outputs the waveform between the start point and end point from the EA-200 speaker. • If the sound you configured cannot be output for some reason, the message "Range Error" will appear. If this happens, press J to scroll back through the previous setting screens and change the setup as required. 12. To terminate sound output, press the EA-200 [START/STOP] key. 13. Press w. • This displays a screen like the one shown nearby. 14. Perform one of the following operations, depending on what you want to do. To change the output frequency and try again: Press 1(Yes) to return to the "Output Frequency" dialog box. Next, repeat the above steps from step 10. To change the output range of the waveform graph and try again: Press 6(No) to return to the graph screen in step 7. Next, repeat the above steps from step 8. To change the function: Press 6(No) and then J to return to the graph relation list in step 6. Next, repeat the above steps from step 6. To exit the procedure and return to the E-Con2 main menu: Press 6(No) and then press J twice. 20100801