Casio FX-CG10 Software User Guide - Page 558
Trigger Setup, To do this, Press this key, To start sampling when this happens
View all Casio FX-CG10 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 558 highlights
ε-13 Using Advanced Setup Important! • When the following condition exists, an "FFT Graph" setting appears in place of the "Warm-up" setting. See "To configure the FFT Graph setting" below, for information about configuring the "FFT Graph" setting. - Sampling mode (page ε-11): Fast 6. After all the settings are the way you want, press w. • This returns to the Advanced Setup menu. • To configure the Distance setting In place of step 3 of the procedure under "To configure Sample Setup settings", press 1 to display a dialog box for specifying the distance the weight travels in meters. • Specify a value in the range of 0.1 to 4 meters. • To configure the FFT Graph setting In place of step 5 of the procedure under "To configure Sample Setup settings", press 1 to display a dialog box for turning frequency characteristic graphing (FFT Graph) on and off. To do this: Turn on graphing of frequency characteristics after sampling Turn off graphing of frequency characteristics after sampling Press this key: 1(On) 2(Off) k Trigger Setup You can use the Trigger Setup screen to specify the event that causes sampling to start (w key operation, etc.). The event that causes sampling to start is called the "trigger source", which is indicated as "Source" on the Trigger Setup screen. The following table describes each of the six available trigger sources. To start sampling when this happens: When the w key is pressed After the specified number of seconds are counted down When input at CH1 reaches a specified value When input at the SONIC channel reaches a specified value When the EA-200's built-in microphone detects sound When the EA-200's [START/STOP] key is pressed Select this trigger source: [EXE] key Count Down CH1 SONIC Mic [START] key 20100801