Celestron StarSense Explorer DX 102AZ Smartphone App-Enabled Refractor Telescope

Celestron StarSense Explorer DX 102AZ Smartphone App-Enabled Refractor Telescope Manual

Get Celestron StarSense Explorer DX 102AZ Smartphone App-Enabled Refractor Telescope PDF manuals and user guides View all Celestron StarSense Explorer DX 102AZ Smartphone App-Enabled Refractor Telescope manuals
Add to My Manuals
Save this manual to your list of manuals

Celestron StarSense Explorer DX 102AZ Smartphone App-Enabled Refractor Telescope manual content summary:

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
ENGLISH | 1
Unpack your telescope and verify that all parts are
present. Your StarSense Explorer DX includes:
a telescope tube, a tripod and mount head, an
accessory bag, slow motion controls, an accessory
tray, two eyepieces, an erect image diagonal, a
finderscope, a StarSense phone dock, StarSense
Explorer app code card, and a hex key (hidden inside
the slot in the front of the mount head).
To set up the tripod, spread the legs outward until
they are fully extended and push down the center leg
brace.
ITEM #22460
Extend the legs of the tripod by loosening the three
hand knobs on each leg.
Pull each leg section all
the way out and tighten the hand knobs to secure
them in place.
ENGLISH
102AZ
Quick Setup Guide
Place the accessory tray on top of the center brace
and line up the three holes. Insert the three thumb
screws through the top of the leg brace and thread
them into the tray.
To attach the slow-motion knobs
to your mount,
first locate the supplied hex key hidden inside the
slot in the front of your mount.
Place the slow-motion control knob over the
D-shaped gear shaft and push inward to make sure
it is fully seated. Use the hex key to tighten the
setscrews onto the gear shaft.
Return the hex key to
its storage position in the front of the mount.
Turn the clamp assembly so that the locking screw is
on top of the dovetail clamp. Hold the telescope tube
next to the mount with the dovetail bar on the tube
facing the clamp on the top of the mount arm.
Slide the dovetail bar into the clamp at the top of
the mount and tighten the hand knob on the bottom
of the clamp to secure the telescope in place.
Locate the erect image diagonal and remove the
plastic covers. Insert the barrel of the diagonal into
the focuser and secure in place by tightening the set
screws.
Insert the barrel of the 25 mm eyepiece into the
diagonal and tighten the set screw.
2
4
5
6
7
8
9
10
1
3