Cisco 3825 Software Configuration Guide - Page 106
Specify the Location of the Interface, class, priority percent
UPC - 746320981505
View all Cisco 3825 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 106 highlights
Configuration Sequence Chapter 4 Configuring the Cisco 3825 Mobile Wireless Edge Router in a RAN-O Solution with the Command-Line Step 3 Step 4 Step 5 Step 6 For example, the following command specifies the class as the llq-class. Router(config-pmap)# class llq-class When you enter the class command, you are in the class submode of the policy-map configuration mode. Allocate a percentage of bandwidth to be used for the prority queue. Router(config-pmap-c)# priority percent number For example, the following command specifies a priority percent number of 99. Router(config-pmap-c)# priority percent 99 Associate the llq-policy with a default class map. The default class is used for non-priority traffic. Router(config-pmap-c)# class class-default Allocate the remaining bandwidth to the default class. Router(config-pmap-c)# bandwitdh remaining percent number For example, the following command specifies the remaining bandwidth as 1 percent. Router(config-pmap-c)# bandwidth remaining percent 1 Limit the queue depth of the default queue. Router(config-pmap-c)# queue-limit number For example, the following command limits the queue depth to 45. Router(config-pmap-c)# queue-limit 45 Note The queue limit on the default class should be less than the hold-queue specified on the multilink interface. Step 7 Exit the class map and policy map configuration modes. Router(config-pmap-c)# exit Router(config-pmap)# exit For more information about these commands, see the Cisco IOS Quality of Service Solutions Command Reference for your Cisco IOS Release. Specify the Location of the Interface Step 1 Step 2 Enter interface configuration mode and specify the location of the interface. Router(config)# interface atmslot/subslot/port For example, the following command specifies the location of the interface as ATM0/0. Router(config# interface atm0/0/0 Disable the IP address configuration for the physical layer interface. Router(config-if)# no ip address 4-48 Cisco 3825 Mobile Wireless Edge Router Software Configuration Guide OL-15667-03