Cisco 3825 Software Configuration Guide - Page 108
Step 7, value
UPC - 746320981505
View all Cisco 3825 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 108 highlights
Configuration Sequence Chapter 4 Configuring the Cisco 3825 Mobile Wireless Edge Router in a RAN-O Solution with the Command-Line Step 7 To set the DSCP value used as the interface default DSCP value to tag the backhaul packet, use the following command: Router(config-if)# umts-iub set dscp value Where value is a number chosen to represent that packet of traffic. For example, the following command specifies the number 16 for the packet of traffic for the umts-iub interface: Router(config-if)# umts-iub set dscp 16 Step 8 Step 9 Perform Steps 5 through 7 to set another PVC 2/2 with a umts-iub interface DSCP of 8. To overwrite the previous PVC 2/1 with a umts-iub interface DSCP of 16, use the following command: Router(config-if)# umts-iub set dscp value Where value is a number chosen to represent that packet of traffic. For example, the following command overwrites the number 16 for the packet of traffic for the umts-iub interface: Router(config-if)# umts-iub set dscp 16 Step 10 To configure the local parameters required to establish an IP/UDP backhaul connection, enter the following command including the IP address and port you want to establish the IP/UDP backhaul connection from. Router(config-if)# umts-iub local ip-address port For example, the following command configures the umts-iub local interface with an IP address and port of 20.20.20.21 6666: Router(config-if)# umts-iub local 20.20.20.21 6666 Step 11 To configure the remote parameters required to establish an IP/UDP backhaul connection, enter the following command including the IP address and port you want to establish the IP/UDP backhaul connection from. Router(config-if)# umts-iub remote ip-address port For example, the following command configures the umts-iub remote interface with an IP address and port of 20.20.20.20 6666: Router(config-if)# umts-iub remote 20.20.20.20 6666 Step 12 Step 13 Perform Steps 1 to 7 for ATM0/0/1 with a UMTS DSCP of 8. To overwrite the previous PVC 2/1 with a umts-iub interface DSCP of 16, use the following command: Router(config-if)# umts-iub set dscp value Where value is a number chosen to represent that packet of traffic. For example, the following command overwrites the number 16 for the packet of traffic for the umts-iub interface: Router(config-if)# umts-iub set dscp 16 Step 14 To configure the local parameters required to establish an IP/UDP backhaul connection, enter the following command including the IP address and port you want to establish the IP/UDP backhaul connection from. Router(config-if)# umts-iub local ip-address port 4-50 Cisco 3825 Mobile Wireless Edge Router Software Configuration Guide OL-15667-03