Cisco 3825 Software Configuration Guide - Page 145
class cem
UPC - 746320981505
View all Cisco 3825 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 145 highlights
Appendix A Cisco 3825 Mobile Wireless Edge Router RAN-O Command Reference class cem class cem Use the class cem command in the global configuration mode to configure CEM interface parameters in a class that's applied to CEM interfaces together. This command works in the same manner for CEM interfaces as pseudowire-class does for xconnect. class cem class-name Syntax Description class-name (Required) The name of a CEM interface parameters class. Command Modes Global configuration Command History Release 12.4(12)MR2 Modification This command was introduced. Usage Guidelines The class cem command allows you to configure CEM interface parameters in a class that's applied to CEM interfaces together. A class cem command includes the following configuration settings: • dejitter-buffer dejitter in ms • idle-pattern Set 8 bit idle pattern • sample-rate Sample rate (in ms) Examples The following example illustrates the use of the class cem command: Router# config t Router(config)# class cem mycemclass Router(config-cem-class)# dejitter-buffer 10 Router(config-cem-class)# sample-rate 2 Router(config-cem-class)# exit Router(config)# interface cem 0/0/0 Router(config-if)# no ip address Router(config-if)# cem 0 Router(config-if-cem)# xconnect 10.10.10.10 200 encapsulation mpls Router(config-if-cem-xconn)# cem class mycemclass Router(config-if-cem)# exit Router(config-if)# exit Router(config)# exit Related Commands Command dejitter-buffer idle-pattern Description Specifies the size of the dejitter-buffer used for the network jitter in the CEM configuration mode. Specifies the data pattern to transmit on the T1/E1 when missing packets are detected on the PWE3 circuit in the CEM configuration mode. OL-15667-03 Cisco 3825 Mobile Wireless Edge Router Software Configuration Guide A-13