Cisco 3825 Software Configuration Guide - Page 150

dejitter-buffer Appendix A Cisco 3825 Mobile Wireless Edge Router RAN-O Command Reference dejitter-buffer To specify the size of the dejitter-buffer used to compensate for the network jitter, use the dejitter-buffer command in the CEM configuration mode. To restore the dejitter-buffer to its default size, use the no form of this command. dejitter-buffer size no dejitter-buffer Syntax Description size Use the size argument to specify the size of the buffer in milliseconds. Size can vary from 4 to 500 ms; default is 4 ms. Defaults The dejitter buffer defaults to 4 milliseconds. Command Modes CEM circuit configuration Command History Release 12.4(12)MR2 Modification This command was introduced. Examples The following example illustrates the use of the dejitter-buffer command: Router# config t Router(config)# interface cem 0/0/0 Router(config-if)# no ip address Router(config-if)# cem 0 Router(config-if-cem)# dejitter-buffer 10 Router(config-if-cem)# xconnect 10.10.10.10 200 encapsulation mpls Router(config-if-cem-xconn)# exit Router(config-if-cem)# exit Router(config-if)# exit Router(config)# exit Related Commands Command cem cem class class cem Description Enters circuit emulation configuration mode. Applies the CEM interface parameters defined in the given to the circuit. Configure's CEM interface parameters in a class that's applied to CEM interfaces together in the global configuration mode. A-18 Cisco 3825 Mobile Wireless Edge Router Software Configuration Guide OL-15667-03