Cisco 3825 Software Configuration Guide - Page 153

Appendix A Cisco 3825 Mobile Wireless Edge Router RAN-O Command Reference gsm-abis congestion abate gsm-abis congestion abate Sets the congestion abatement detection level at which the remote router will stop suppressing timeslots because congestion has been alleviated. The abate detection level is defined as x milliseconds of continuous congestion abatement (that is, no congestion indications). To set the abate detection, use the gsm-abis congestion abate Interface configuration command. gsm-abis congestion abate [ms] Syntax Description ms Sets the number of milliseconds for the abate detection level. Defaults There are no default settings or behaviors. Command Modes Interface configuration Command History Release 12.4(2)MR Modification This command was introduced. Examples The following example shows how to the gsm-abis abate command is set at 250 ms: Router(config)# interface Serial10/1/0:0 Router(config-if)# no ip address Router(config-if)# encapsulation gsm-abis Router(config-if)# load-interval 30 Router(config-if)# gsm-abis local 10.10.10.2 6661 Router(config-if)# gsm-abis remote 10.10.10.1 5553 Router(config-if)# gsm-abis congestion enable Router(config-if)# gsm-abis congestion abate 250 Router(config-if)# no keepalive Related Commands Command gsm-abis congestion critical gsm-abis congestion enable gsm-abis congestion onset gsm-abis jitter Description Defines the critical timeslots that are exempt from suppression during congestion onset. Sets the congestion detection algorithm to monitor the transmit jitter buffer and to send congestion indicator signals to the remote when congestion is detected. Sets the congestion onset detection level at which the remote router will start suppressing all timeslots that are not defined as critical in an effort to alleviate the congestion. Sets the amount of transmit jitter delay for the GSM-Abis interface. OL-15667-03 Cisco 3825 Mobile Wireless Edge Router Software Configuration Guide A-21