Cisco 3825 Software Configuration Guide - Page 167

Appendix A Cisco 3825 Mobile Wireless Edge Router RAN-O Command Reference idle-pattern idle-pattern To specify the data pattern transmitted on the T1/E1 when missing packets are detected on the PWE3 circuit, use the idle-pattern command in CEM configuration mode. idle-pattern [pattern] no idle-pattern Syntax Description pattern An 8-bit hexadecimal number that is transmitted as the idle pattern. Defaults Default idle-pattern is 0xFF. Command Modes CEM circuit configuration Command History Release 12.4(12)MR2 Modification This command was introduced. Usage Guidelines The idle-pattern data is sent to replace the data from missing packets. Examples The following example illustrates the use of the idle-pattern command: Router# config t Router(config)# interface cem 0/0/0 Router(config-if)# no ip address Router(config-if)# cem 0 Router(config-if-cem)# idle-pattern 0x55 Router(config-if-cem)# xconnect 10.10.10.10 200 encapsulation mpls Router(config-if-cem-xconn)# exit Router(config-if-cem)# exit Router(config-if)# exit Router(config)# exit Related Commands Command cem cem class class cem Description Enters circuit emulation configuration mode. Applies the CEM interface parameters defined in the given to the circuit. Configure's CEM interface parameters in a class that's applied to CEM interfaces together in the global configuration mode. OL-15667-03 Cisco 3825 Mobile Wireless Edge Router Software Configuration Guide A-35