Cisco 3825 Software Configuration Guide - Page 168

ima-group Appendix A Cisco 3825 Mobile Wireless Edge Router RAN-O Command Reference ima-group To define physical links as inverse multiplexing over ATM (IMA) group members, use the ima-group Interface configuration command. When you first perform the configuration or when you change the group number, the interface is automatically disabled, moved to the new group, and then enabled. To remove the port from the group, use the no form of this command. ima-group group-number Syntax Description group-number Specifies an IMA group number from 0 to 3. IMA groups can span multiple ports on a port adapter but cannot span port adapters. Defaults Physical links are not included in IMA groups. Command Modes Interface configuration Command History Release 12.0(5)XK 12.4(4)MR Modification This command was introduced. This command was incorporated. Usage Guidelines Use the ima-group interface command to configure a T1/E1 IMA port adapter interface as part of an IMA group. Examples The following example shows how to define an IMA group: Router(config)# interface ATM0/0/0 Router(config-if)# no ip address Router(config-if)# no atm ilmi-keepalive Router(config-if)# ima-group 0 Related Commands Command interface atm interface atm ima show ima interface atm Description Configures an ATM interface. Configures an ATM IMA group. Provides information about configured IMA groups or a specific IMA group. A-36 Cisco 3825 Mobile Wireless Edge Router Software Configuration Guide OL-15667-03