Cisco 6941 Administration Guide - Page 174
Before You Begin, Installing the Bracket - phone wall bracket
UPC - 882658277801
View all Cisco 6941 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 174 highlights
Before You Begin Appendix Before You Begin You will need these tools to install the bracket: • #1 and #2 Phillips-head screwdrivers • Level You must also install an Ethernet jack for the telephone in the desired location if an Ethernet jack does not currently exist. This jack must be wired appropriately for an Ethernet connection. You cannot use a regular telephone jack. For more information on phone installation requirements and warnings, see the Setting Up the Cisco Unified IP Phone chapter. Installing the Bracket To install the phone on the wall, perform the following steps: Procedure Step 1 Mount the wall bracket in the desired location (Figure E-2). You can install the bracket over an Ethernet jack, or you can run the Ethernet network cable to a jack nearby. a. Use the level to ensure the bracket is level, then use a pencil to mark the screw holes. b. Using a #2 Phillips-head screwdriver, carefully center the anchor over the pencil mark and press the anchor into the wall. c. Screw the anchor clockwise into the wall until it is seated flush. d. Use the included screws and a #2 Phillips-head screwdriver to attach the bracket to the wall. Cisco Unified IP Phone 6921, 6941, 6945, and 6961 Administration Guide for Cisco Unified Communications Manager 8.5 (SCCP and SIP) E-2 OL-23769-01