Cisco 6941 Administration Guide - Page 79
PC VLAN, Apply, Select, System > Enterprise Phone, Configuration, Option, Description, To Change
UPC - 882658277801
View all Cisco 6941 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 79 highlights
Chapter Network Setup Menu Table 4-1 Network Setup Menu Options (continued) Option PC VLAN SW Port Setup Description To Change Allows the phone to interoperate with 3rd party switches that do not support a voice VLAN. The Admin VLAN ID option must be set before you can change this option. 1. Make sure the Admin VLAN ID option is set. 2. Scroll to the PC VLAN option, press the Edit softkey, and then enter a new PC VLAN setting. 3. Press the Apply softkey, then press Save. Speed and duplex of the network port. Valid values: 1. Unlock network setup options. • Auto Negotiate • 1000 Full-1000-BaseT/full duplex (Supported only for Cisco Unified IP Phone 6945.) • 100 Half-100-BaseT/half duplex • 100 Full-100-BaseT/full duplex 2. Scroll to the SW Port Setup option and then press the Edit softkey. 3. Scroll to the setting that you want and then press the Select button. • 10 Half-10-BaseT/half duplex • 10 Full-10-BaseT/full duplex If the phone is connected to a switch, configure the port on the switch to the same speed/duplex as the phone, or configure both to auto-negotiate. If you change the setting of this option, you must change the PC Port Configuration option to the same setting. To configure the setting on multiple phones simultaneously, enable the Switch Port Remote Configuration in the Enterprise Phone Configuration (System > Enterprise Phone Configuration). Note If the ports are configured for Switch Port Remote Configuration in Unified CM, the data cannot be changed on the phone. Cisco Unified IP Phone 6921, 6941, 6945, and 6961 Administration Guide for Cisco Unified Communications Manager 8.5 (SCCP and SIP) OL-23769-01 4-5