Cisco AIR-AP1242AG-A-K9 Hardware Installation Guide - Page 58
CDP_PD-2-POWER_LOW: All radios disabled - LOW_POWER_CLASSIC_NO_INJECTOR
UPC - 882658021961
View all Cisco AIR-AP1242AG-A-K9 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 58 highlights
Low Power Condition Chapter 3 Troubleshooting 1240AG Series Autonomous Access Points • %CDP_PD-2-POWER_LOW: All radios disabled - NEGOTIATED inline power source-This message indicates the access point is in low power mode with all radios disabled because the Cisco power source has indicated it is not capable of supplying sufficient power to the access point. Note A Cisco power injector might be required. • %CDP_PD-2-POWER_LOW: All radios disabled - LOW_POWER_CLASSIC_NO_INJECTOR _CONFIGURED (). -This message indicates the access point is in low power mode with all radios disabled and has detected a CDP device that is unable to supply sufficient power to the access point. The< platform name> indicates the CDP device detected by the access point. The indicates the MAC address of the CDP device, typically, the switch port. Note A Cisco power injector might be required. Following the low power status message, two extra messages are displayed on the console port or when using a Telnet session that identify the actions needed to resolve this low power problem: - Verify the required power injector is installed on this port: (). (where indicates the CDP device detected by the access point and indicates the Ethernet port of the CDP device. - If a power injector is installed, issue the command: power inline negotiation injector installed. • %CDP_PD-2-POWER_LOW: All radios disabled- LOW_POWER_CLASSIC_INJECTOR_ CONFIGURED_ON_ANOTHER_PORT ()-This message indicates the access point is in low power mode with all radios disabled and has detected a CDP device that is unable to supply sufficient power to the access point. A power injector has been configured, but it is for another port. It is likely that the access point has been relocated and has not been reconfigured for a new power injector. The indicates the CDP device detected by the access point. The indicates the MAC address of the CDP device, typically, the switch port. Note A Cisco power injector might be required. Following the low power status message, two extra messages are displayed when using the console port or a Telnet session that identify the actions needed to resolve this low power problem: 1. Verify the required power injector is installed on the new port: (). (where indicates the CDP device detected by the access point and indicates the Ethernet port of the CDP device. 2. If a power injector is installed, issue the command: power inline negotiation injector installed. • %CDP_PD-2-POWER_LOW: All radios disabled- HIGH_POWER_CLASSIC_NOT_ CONFIGURED inline power source ()-This message indicates the access point is in low power mode with all radios disabled and has detected a Cisco switch that does not support Intelligent Power Management, but should be able to supply sufficient power. The access point must be configured for pre-standard compatibility. Cisco Aironet 1240AG Series Access Point Hardware Installation Guide 3-8 OL-8371-05