Cisco AIR-LAP1141N-A-K9 Getting Started Guide - Page 9
Pre-Installation Configuration Setup, Controller, Layer 3, devices, Cisco Aironet, access points
UPC - 882658245978
View all Cisco AIR-LAP1141N-A-K9 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 9 highlights
Pre-Installation Configuration Setup Figure 3 shows the pre-installation configuration setup. Figure 3 Pre-Installation Configuration Setup Controller Layer 3 devices Cisco Aironet access points 272488 Follow these steps to perform the pre-installation configuration. Step 1 Make sure that the Cisco wireless LAN controller DS port is connected to the network. Use the CLI, web-browser interface, or Cisco WCS procedures as described in the appropriate Cisco wireless LAN controller guide. a. Make sure that access points have Layer 3 connectivity to the Cisco wireless LAN controller Management and AP-Manager Interface. b. Configure the switch to which your access point is to attach. See the Cisco Unified Wireless Network WLAN Controller Guide: Cisco 440x Series WLAN Controllers for additional information. c. Set the Cisco wireless LAN controller as the master so that new access points always join with it. d. Make sure DHCP is enabled on the network. The access point must receive its IP address through DHCP. 9