Cisco ASR1006 Hardware Installation Guide - Page 152
SPA Installation and Removal, Installing a SPA in a SIP, Removing a SPA from a SIP - accessory kit
UPC - 882658196423
View all Cisco ASR1006 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 152 highlights
SPA Installation and Removal Figure 6-1 Handling a SPA Metal carrier Printed circuit board Chapter 6 Installing and Removing a SPA H6420 SPA Installation and Removal This section provides step-by-step instructions for installing and removing a SPA in a SIP. Caution When performing the following procedures, wear a grounding wrist strap to avoid ESD damage to the SPA. Some platforms have an ESD connector for attaching the wrist strap. Do not directly touch the midplane or backplane with your hand or any metal tool. See Preventing Electrostatic Discharge Damage, page 4-8 for information about ESD. Installing a SPA in a SIP To install a SPA in a SIP, do the following: Step 1 Step 2 Step 3 To insert the SPA in the SIP, locate the guide rails inside the SIP that hold the SPA in place. They are at the top left and top right of the SPA slot and are recessed about an inch. Carefully slide the SPA all the way in the SIP until the SPA is firmly seated in the SPA interface connector. When fully seated, the SPA might be slightly behind the SIP faceplate. After the SPA is properly seated, fasten the SPA in place with the captive installation screws on either side of the SPA. Removing a SPA from a SIP Before you remove a SPA from the SIP, read this important information about SPA cable clips that will help to make removing the SPA easier. The SPA accessory kit is shipped with three different versions of cable clips, as shown in Figure 6-3. Cisco ASR 1000 Series Aggregation Services Routers SIP and SPA Hardware Installation Guide 6-2 OL-14126-12