Cisco ASR1006 Hardware Installation Guide - Page 61
-Port Copper and Optical Gigabit Ethernet SPA Cables, Connectors, and Pinouts, SFP Module Connections - asr show traffic
UPC - 882658196423
View all Cisco ASR1006 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 61 highlights
Chapter 3 Overview: Cisco ASR 1000 Series Aggregation Services Routers SPAs 2-Port Gigabit Ethernet SPA Overview Table 3-10 LED Label 2-Port Copper and Optical Gigabit Ethernet SPA LEDs (continued) Color Green Amber State On On Meaning SPA is ready and operational. SPA power is on and good, and SPA is being configured. 2-Port Copper and Optical Gigabit Ethernet SPA Cables, Connectors, and Pinouts The 2-Port Copper and Optical Gigabit Ethernet SPA has two individual fiber-optic receivers that support SFP modules. Each port can send and receive traffic using the optical fiber connections. SFP Module Connections The small form-factor pluggable (SFP) module is an input/output (I/O) device that plugs into the Gigabit Ethernet ports on the 2-Port Copper and Optical Gigabit Ethernet SPA, linking the port with a fiber-optic network. Note The 2-Port Copper and Optical Gigabit Ethernet SPA will only accept the SFP modules listed as supported in this document. An SFP module check is run every time an SFP module is inserted into the 2-Port Copper and Optical Gigabit Ethernet SPA and only SFP modules that pass this check will be usable by the 2-Port Copper and Optical Gigabit Ethernet SPA. SFP modules exist for technologies other than Gigabit Ethernet and for products other than the 2-Port Copper and Optical Gigabit Ethernet SPA. However, the information in this document pertains only to SFP modules that plug into the 2-Port Copper and Optical Gigabit Ethernet SPA ports. See the "SFP Module and Cabling Specifications for Gigabit Ethernet SPAs" section on page 3-25 for SFP module options, module specifications, and cabling specifications. For CWDM and DWDM SFP module specifications, see the "CWDM and DWDM SFP Modules for Gigabit Ethernet SPAs" section on page 3-29. Cables, Connectors, and Pinouts In addition to the two fiber-optic receivers, the 2-Port Copper and Optical Gigabit Ethernet SPA has two individual RJ-45 receptacles. You can use both interface connectors simultaneously. Each connection supports IEEE 802.3 and Ethernet 10/100BASE-T interfaces compliant with appropriate standards. Cisco does not supply Category 5 unshielded twisted pair (UTP) RJ-45 cables; these cables are available commercially. Figure 3-16 shows the RJ-45 connector. Table 3-11 lists the pinouts and signals for the RJ-45 connector. OL-14126-12 Cisco ASR 1000 Series Aggregation Services Routers SIP and SPA Hardware Installation Guide 3-19