Cisco MDS-9124 Troubleshooting Guide - Page 268

IVR Issues Chapter 13 Troubleshooting IVR Send documentation comments to [email protected] IVR Network Address Translation Fails Symptom IVR NAT fails. Table 13-5 IVR NAT Fails Symptom IVR NAT fails. Possible Cause Internal message payload uses destination ID. Some switches are running IVR without NAT. Solution IVR NAT modifies the destination ID in the Fibre Channel header. If this same destination ID appears inside the message payload, Cisco SAN-OS may not detect it and IVR NAT fails. Disable IVR NAT and ensure that all domain IDs are unique. Refer to the Cisco MDS 9000 Family configuration guides at the following website for a list of payloads that work with IVR NAT when the payload includes the destination ID: http://www.cisco.com/en/US/products/ps5989/products_inst allation_and_configuration_guides_list.html You cannot combine IVR and IVR NAT in the same VSAN. Use the same IVR configuration on all switches. Deactivate the active zone set before converting to IVR or IVR NAT. IVR Zone Set Activation Fails If zone set activation fails, you may see the following system messages: Error Message IVR-2-IVZS_ACTIVATION_FAILED_RETRYING: Inter-VSAN zoneset activation failed in VSAN [dec] : [chars]. retrying after [dec] seconds. Explanation Inter-VSAN zone set activation failed in the listed VSAN. This could be an intermittent, regular zone set activation error. The activation will be retried after the number of seconds listed in the message. Recommended Action No action is required. Introduced Cisco MDS SAN-OS Release 2.1(2). Error Message IVR-3-IVZ_ACTIVATION_FAILED: Inter-VSAN zoneset [chars] activation failed. Explanation Inter-VSAN zone set activation failed. Recommended Action No action is required. Introduced Cisco MDS SAN-OS Release 1.3(1). 13-8 Cisco MDS 9000 Family Troubleshooting Guide, Release 3.x OL-9285-05