Cisco MDS-9124 Troubleshooting Guide - Page 289

Chapter 14 Troubleshooting Zones and Zone Sets Zone and Zone Set Issues Send documentation comments to [email protected] Step 6 Step 7 Use the zoneset activate command to activate the zone set. switch(config)# zoneset activate ZoneSet1 vsan 2 If you are still experiencing zone set activation failure, use the show zone internal change event-history vsan command to determine the source of the zone set activation problem. Troubleshooting Full Zone Database Synchronization Across Switches All switches in the Cisco MDS 9000 Family distribute active zone sets when new E port links come up or when a new zone set is activated in a VSAN. The zone set distribution takes effect while sending merge requests to the adjacent switch or while activating a zone set. Resolving Out of Sync Full Zone Database Using Fabric Manager To verify if the full zone database is in sync across switches using Fabric Manager, follow these steps: Step 1 Step 2 Step 3 Choose Fabricxx > VSANxx > zonesetname and select the Policies tab. Verify that the Propagation field is set to FullZoneSet. If it is not, select FullZoneSet from the drop-down menu. Click Apply Changes to save these changes. Resolving an Out of Sync Full Zone Database Using the CLI To verify if the full zone database is in sync across switches using the CLI, follow these steps: Step 1 Step 2 Use the show zone status command to verify if the distribute flag is on. switch# config t show zone status VSAN: 1 default-zone: deny distribute: active only Interop: default mode: basic merge-control: allow session: none hard-zoning: enabled Default zone: qos: low broadcast: disabled ronly: disabled Full Zoning Database : Zonesets:3 Zones:7 Aliases: 9 Active Zoning Database : Name: ZoneSet1 Zonesets:1 Zones:2 Status: This example shows that only the active zone set is distributed. Verify that the distribute flag is on. OL-9285-05 Cisco MDS 9000 Family Troubleshooting Guide, Release 3.x 14-11