Cisco MDS-9124 Troubleshooting Guide - Page 82

Miscellaneous Software Image Issues Chapter 2 Troubleshooting Installs, Upgrades, and Reboots Send documentation comments to [email protected] Cannot Create, Modify, or Delete Admin Role Symptom Cannot create, modify, or delete the admin role. Table 2-12 Cannot Create, Modify, or Delete Admin Role Symptom Cannot create, modify, or delete the admin role. Possible Cause After upgrading to Cisco SAN-OS Release 2.0, you cannot create, modify, or delete the admin role. Solution Create the admin role before upgrading to Cisco SAN-OS Release 2.0. FC IDs Change after Link Reset Symptom FC IDs change after a link resets. Table 2-13 FC IDs Change After a Link Reset Symptom FC IDs change after a link resets. Possible Cause Solution Following an upgrade from Cisco SAN-OS Release 1.1 to Cisco SAN-OS Release 1.3 or later, with persistent FC ID enabled, the FC IDs for the storage arrays might change after a link flap. Reconfigure the FC IDs as necessary. Switch Displays Wrong User Symptom Switch displays the wrong user with the show running-config CLI command. Table 2-14 Switch Displays Wrong User Symptom Switch displays the wrong user with the show running-config CLI command. Possible Cause Solution When you perform a nondisruptive upgrade from Cisco SAN-OS Release 1.3(x) to Cisco SAN-OS Release 2.0(x) and then issue the show running-config command, the switch displays the wrong user. The user shown after the nondisruptive upgrade is different from the user shown when you issue the show user-account command. Recreate the user. 2-34 Cisco MDS 9000 Family Troubleshooting Guide, Release 3.x OL-9285-05