Cisco SPA525G Administration Guide - Page 137

Provisioning Basics Provisioning Capabilities 7 To provision from the phone: SPA9X2 STEP 1 Press Setup, then scroll to Profile Rule. STEP 2 Enter the profile rule using the following format, then press the Resync soft button. protocol://server[:port]/profile_pathname For example: tftp://192.168.1.5/spa942.cfg If no protocol is specified, TFTP is assumed. If no server-name is specified, the host that requests the URL is used as server-name. If no port is specified, the default port is used (69 for TFTP, 80 for HTTP, and 443 for HTTPS). then the address can be entered in and press Resync. The status of the remote customization process is shown by the phone's mute button blinking in the following patterns: • Red/orange slow blink (1.0 seconds on, 1.0 seconds off): Contacting server, server not resolvable, not reachable, or down • Red/orange slow blink (0.2 seconds on, 0.2 seconds off, 0.2 seconds on, 1.4 seconds off): Server responded with file not found or corrupt file WIP310 STEP 1 Press the Select button to choose Settings and press the Select button again. STEP 2 Navigate to Misc Settings. STEP 3 Navigate to profile rule. Enter the profile rule in the following format: protocol://server[:port]/profile_pathname For example, to have the WIP310 provisioning done by the Cisco SPA9000 Voice System, enter: 192.168.2.64/cfg/generic.xml Cisco SPA and Wireless IP Phone Administration Guide 135