Cisco SPA525G Administration Guide - Page 164
SPA9000 Voice, System Administration Guide, STEP 1 - vpn configuration
UPC - 882658261688
View all Cisco SPA525G manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 164 highlights
8 Configuring Regional Parameters and Supplementary Services Using a Dial Plan If the phone is part of a SPA9000 system, you create a dial plan for the system that is then propagated to the individual phones. In certain cases, you must configure the dial plan on individual phones: • If the phone is outside the SPA9000 multicast domain (e.g. when the phone is connected to the SPA9000 via a VPN connection). • For additional extensions on an existing phone (the system wide phone dial plan is propagated only to extension 1 of all phones). For information on configuring the SPA9000 Dial Plan, see the SPA9000 Voice System Administration Guide. You can configure a dial plan with three interdigit timers: • Initial timeout (T)-Handset off hook; no digit pressed yet. • Long timeout (L)-One or more digits pressed, more digits needed to reach a valid number (as per the dial plan). • Short timeout (S)-Current dialed number is valid, but more digits would also lead to a valid number. To configure dial plans on specific phone extensions: STEP 1 Log in to the web administration interface. STEP 2 Click Admin Login and advanced. STEP 3 Click the Ext tab. STEP 4 Under Dial Plan, configure the dial plan parameters. See the following table for information: 162 Cisco SPA and Wireless IP Administration Phone Guide