Cisco SPA525G Administration Guide - Page 94
Configuring SIP, SPCP, and NAT, SPA932 Attendant Console., Parameter, Description
UPC - 882658261688
View all Cisco SPA525G manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 94 highlights
5 Configuring SIP, SPCP, and NAT Configuring SIP Parameter Description CTI Enable If set to yes, enables the computer telephony integration (CTI), where a computer can act as a call center handling all sorts of incoming and outgoing communications., including phone calls, faxes, and text messages. The CTI interface allows a third-party application to control and monitor the state of a Cisco IP phone and, for example, initiate or answer a call by clicking a mouse on a PC, NOTE: CTI must be enabled on the SPA962 for an attached SPA932 to properly monitor the SPA962's line status. If setting up a SPA932, see Chapter 9, "Configuring the SPA932 Attendant Console." Defaults to no. Caller ID Header Select where the SPA9X2/525G gets its caller ID from: PAID-RPID-FROM P-ASSERTED-IDENTITY REMOTE-PARTY-ID FROM header Defaults to PAID-RPID-FROM. NOTE: Not applicable to the WIP310. SRTP Method Selects the method to use for SRTP. Two choices are available: • x-sipura-legacy SRPT method • s-descriptor-new method compliant with RFC-3711 and RFC-4568 The default value is "x-sipura." NOTE Not applicable to WIP310. Hold Target Before REFER Controls whether to hold call leg with transfer target before sending REFER to the transferee when initiating a fully-attended call transfer (where the transfer target has answered). Default value is "no," where the call leg is not held. NOTE Not applicable to WIP310. 92 Cisco SPA and Wireless IP Phone Administration Guide