Cisco WAP610N User Guide

Cisco WAP610N Manual

Get Cisco WAP610N PDF manuals and user guides View all Cisco WAP610N manuals
Add to My Manuals
Save this manual to your list of manuals

Cisco WAP610N manual content summary:

  • Cisco WAP610N | User Guide - Page 1
    USER GUIDE Wireless-N Access Point with Dual-Band Model: WAP610N
  • Cisco WAP610N | User Guide - Page 2
    Cisco Systems, Inc. and/or its affiliates in the U.S. and certain other countries. Other brands and product names are trademarks or registered trademarks of their respective holders. Copyright © 2009 Cisco Systems, Inc. All rights reserved. Wireless-N Access Point with Dual-Band About This Guide
  • Cisco WAP610N | User Guide - Page 3
    11 Administration > Management 12 Administration > Factory Defaults 12 Administration > Firmware Upgrade 12 Status > Access Point 13 Status > Wireless Network 13 Status > About 13 Appendix A: Troubleshooting 14 Appendix B: Specifications 15 Appendix C: Warranty Information 16 Limited
  • Cisco WAP610N | User Guide - Page 4
    sure the client device supports Wi‑Fi Protected Setup™. Wait until the LED is off, and then try again. Wireless-N Access Point with Dual-Band Ethernet The Ethernet port connects the Access Point to a router. Reset There are two ways to reset the Access Point's factory defaults. Either press and
  • Cisco WAP610N | User Guide - Page 5
    by the factory. The Linksys default password is admin. Hackers know these defaults and may try to use them to access your wireless device and change your network settings. To thwart any unauthorized changes, customize the device's password so it will be hard to guess. 3. Enable MAC address filtering
  • Cisco WAP610N | User Guide - Page 6
    the password you created during the Setup Wizard. If you did not create a new password, use the default password admin. (You can set a new password from the Administration > Management screen.) Click OK to continue. Password Screen Wireless-N Access Point with Dual-Band Advanced Configuration NOTE
  • Cisco WAP610N | User Guide - Page 7
    Then proceed to "Wi-Fi Protected Setup™" on page 6. Basic Wireless Settings (Manual) Wireless > Basic Wireless Settings (Manual) Wireless Band This is used to select the 2.4 GHz or 5.0 GHz band. Wireless-N Access Point with Dual-Band Advanced Configuration Network Mode (5 GHz) From this drop-down
  • Cisco WAP610N | User Guide - Page 8
    your changes. Wireless-N Access Point with Dual-Band Security Mode > WPA Enterprise Encryption WPA supports the TKIP encryption method, with dynamic encryption keys. RADIUS Server Enter the IP Address of the RADIUS server. RADIUS Port Enter the port number of the RADIUS server. The default value
  • Cisco WAP610N | User Guide - Page 9
    method, which is not as secure as WPA or WPA2. Wireless-N Access Point with Dual-Band Advanced Configuration Security Mode > WEP Encryption Select a level of WEP encryption, 40/64 bits (10 hex digits) or 104/128 bits (26 hex digits). The default is 40/64 bits (10 hex digits). Key 1 Enter the
  • Cisco WAP610N | User Guide - Page 10
    client device has been configured, click OK. Then refer back to your client device or its documentation for further instructions Wireless-N Access Point with Dual-Band Wireless > Wireless MAC Filter Wireless MAC Filter Enabled/Disabled To filter wireless users by MAC Address, either permitting or
  • Cisco WAP610N | User Guide - Page 11
    on the WMM screen are designed for advanced users only. Wireless-N Access Point with Dual-Band Advanced Configuration WMM® Access Mode You can assign different settings to the four access modes available. Select the mode you want to configure: Background, Best Effort, Video, or Voice. Follow the
  • Cisco WAP610N | User Guide - Page 12
    in the aggregate. The range is 0 to 1500. The default is 10. ADDBA Timeout This option defines the duration after which the ADDBA setup is terminated, if there without getting ACKs. The range is 0 to 64. The default is 64. Wireless-N Access Point with Dual-Band Advanced Configuration CW Min for STA
  • Cisco WAP610N | User Guide - Page 13
    in the aggregate. The range is 0 to 2. The default is 2. Wireless-N Access Point with Dual-Band Advanced Configuration Max. Aggregation Size This the aggregate. The range is 0 to 1500. The default is 10. ADDBA Timeout This option defines the duration after which the ADDBA setup is terminated, if
  • Cisco WAP610N | User Guide - Page 14
    , and All, when the Access Point can transmit at all wireless rates. The Basic Rate is not the actual rate of Wireless-N Access Point with Dual-Band Advanced Configuration data transmission. If you want to specify the Access Point's rate of data transmission, configure the Transmission Rate setting
  • Cisco WAP610N | User Guide - Page 15
    to block wireless access to the utility. Wireless-N Access Point with Dual-Band Administration > Factory Defaults Administration > Firmware Upgrade Use this screen to upgrade the Access Point's firmware. Do not upgrade the firmware unless you are experiencing problems with the Access Point or the
  • Cisco WAP610N | User Guide - Page 16
    method used by the Access Point is displayed. SSID Broadcast The status of SSID broadcast (enabled or disabled) is displayed. Status > About Information about the browser-based utility is displayed. Wireless-N Access Point with Dual-Band Status > About Web Server Powered By The web server
  • Cisco WAP610N | User Guide - Page 17
    Unplug the power adapter from the Access Point. 2. Wait five seconds, and then plug the power adapter back into the Access Point. 3. On your web browser, click Refresh. Wireless-N Access Point with Dual-Band Troubleshooting WEB: If your questions are not addressed here, refer to the Linksys website
  • Cisco WAP610N | User Guide - Page 18
    Windows XP, Vista, or Vista 64-Bit Edition with Latest Updates (for Setup Wizard only) Environmental Dimensions 5.71" x 4.17" x 2.05" (145 x 106 x 52 mm) Weight 5.61 oz (159 g) Wireless-N Access Point with Dual-Band Specifications Power 12V, 1A Certification FCC, UL/cUL, ICES-003, RSS210
  • Cisco WAP610N | User Guide - Page 19
    LAW, ALL SOFTWARE PROVIDED BY LINKSYS WITH THE PRODUCT, WHETHER FACTORY LOADED ON THE PRODUCT OR CONTAINED ON MEDIA ACCOMPANYING THE PRODUCT, IS PROVIDED "AS IS" WITHOUT WARRANTY OF ANY KIND. Without limiting the foregoing, Linksys does Wireless-N Access Point with Dual-Band Warranty Information
  • Cisco WAP610N | User Guide - Page 20
    ) can be found at www.linksysbycisco.com/support. This limited warranty is governed by the laws of the jurisdiction in which the Product was purchased by you. Please direct all inquiries to: Linksys, P.O. Box 18558, Irvine, CA 92623. Warranty Information Wireless-N Access Point with Dual-Band 17
  • Cisco WAP610N | User Guide - Page 21
    your body. Wireless-N Access Point with Dual-Band Regulatory Information The availability of some specific channels and/or operational frequency bands is country dependent and programmed at the factory to match the intended destination. This setting is not accessible by the end user. Safety Notices
  • Cisco WAP610N | User Guide - Page 22
    users must follow the specific operating instructions 1.58 1.45 N/A Because high power radars are allocated as primary users (meaning they have priority) in band 5600-5650 MHz, so that Environment Canada weather radars operating in this band are protected. Wireless-N Access Point with Dual-Band
  • Cisco WAP610N | User Guide - Page 23
    specifications. Actual performance can vary, including lower wireless network capacity, data throughput rate, range and coverage. Performance depends on many factors, conditions and variables, including distance from the access point Regulatory Information Wireless-N Access Point with Dual-Band 20
  • Cisco WAP610N | User Guide - Page 24
    Equipment (WEEE) This document contains important information for users with regards to the proper disposal and recycling of Linksys products. Consumers are required to comply with this notice oder an den Händler, bei dem Sie das Produkt erworben haben. Wireless-N Access Point with Dual-Band 21
  • Cisco WAP610N | User Guide - Page 25
    publique. Pour plus d'informations sur le mode d'élimination de votre ancien équipement, veuillez prendre contact avec les pouvoirs publics locaux, le service de traitement des déchets, ou l' dienestā, kā arī veikalā, kur iegādājāties šo izstrādājumu. Wireless-N Access Point with Dual-Band 22
  • Cisco WAP610N | User Guide - Page 26
    . W celu uzyskania szczegółowych informacji o usuwaniu starego sprzętu, prosimy zwrócić się do lokalnych władz, służb oczyszczania miasta lub sklepu, w którym produkt został nabyty. Wireless-N Access Point with Dual-Band 23
  • Cisco WAP610N | User Guide - Page 27
    kassering av din gamla utrustning kontaktar du dina lokala myndigheter, avfallshanteringen eller butiken där du köpte produkten. WEB: For additional information, please visit www.linksysbycisco.com Wireless-N Access Point with Dual-Band 24
  • Cisco WAP610N | User Guide - Page 28
    NOT DOWNLOAD, INSTALL OR USE THE SOFTWARE. YOU MAY RETURN UNUSED SOFTWARE (OR, IF THE SOFTWARE IS SUPPLIED AS PART OF ANOTHER PRODUCT, THE UNUSED PRODUCT) FOR A FULL REFUND UP TO 30 DAYS AFTER ORIGINAL PURCHASE, SUBJECT TO Wireless-N Access Point with Dual-Band Software End User License Agreement
  • Cisco WAP610N | User Guide - Page 29
    of the service. Cisco makes no representations as to the quality, Wireless-N Access Point with Dual-Band Software End User License Agreement Cisco and/ or a third party at periodic intervals while the computer is online. This information is associated and stored with the email address supplied
  • Cisco WAP610N | User Guide - Page 30
    browser software, including the default settings for search provider and source of DNS error pages and may direct erroneous URLs to an error landing page hosted by Cisco. You may opt out of these settings by not accepting them as Wireless-N Access Point with Dual-Band Software End User License
  • Cisco WAP610N | User Guide - Page 31
    between the parties with respect to the Software and Wireless-N Access Point with Dual-Band Software End User License Agreement supersedes any conflicting or additional terms contained in any purchase order or elsewhere. Linksys, Cisco and the Cisco Logo and other trademarks contained in the
  • Cisco WAP610N | User Guide - Page 32
    software, we are referring to freedom, not price. Our General Public Licenses are designed to make sure that you have the freedom to distribute copies of free software (and charge for this service software, or if you modify it. Wireless-N Access Point with Dual-Band Software End User is addressed as
  • Cisco WAP610N | User Guide - Page 33
    your rights to work written entirely by you; rather, the intent is to exercise the right to control the Wireless-N Access Point with Dual-Band Software End User License Agreement distribution of derivative or collective works based on the Program. In addition, mere aggregation of another work
  • Cisco WAP610N | User Guide - Page 34
    wide range of software distributed through that system in reliance Wireless-N Access Point with Dual-Band Software End User License Agreement in spirit to the present version, but may differ in detail to address new problems or concerns. Each version is given a distinguishing version number. If the
  • Cisco WAP610N | User Guide - Page 35
    CONDITIONS END OF SCHEDULE 3-A Schedule 3-B If this Cisco product contains open source software licensed under Version 2.1 of the "GNU Lesser Wireless-N Access Point with Dual-Band Software End User License Agreement When we speak of free software, we are referring to freedom of use, not price
  • Cisco WAP610N | User Guide - Page 36
    License"). Each licensee is addressed as "you". A "library" means a collection of software functions and/or data of it, Wireless-N Access Point with Dual-Band Software End User License Agreement either an application does not supply such function or table, the facility still operates, and
  • Cisco WAP610N | User Guide - Page 37
    software interchange. Wireless-N Access Point with Dual-Band Software End User License Agreement If distribution of object code is made by offering access to copy from a designated place, then offering equivalent access use are covered by this License. You must supply a copy of this License. If the
  • Cisco WAP610N | User Guide - Page 38
    you cannot use both them and the Library together in an executable that you distribute. Software End User License Agreement 7. You may place library facilities that are a work based on the for enforcing compliance by third parties with this License. Wireless-N Access Point with Dual-Band 35
  • Cisco WAP610N | User Guide - Page 39
    generous contributions to the wide range of software distributed through that system in version, but may differ in detail to address new problems or concerns. Each version is given a Software Foundation. If the Library does not specify a Wireless-N Access Point with Dual-Band Software End User
  • Cisco WAP610N | User Guide - Page 40
    Cisco product contains open source software licensed under the OpenSSL license then the license terms below in this Schedule 3-C will apply to that open source software permission of the OpenSSL Project. Wireless-N Access Point with Dual-Band Software End User License Agreement 6. Redistributions of
  • Cisco WAP610N | User Guide - Page 41
    version or derivative of this code cannot be changed. i.e. this code cannot simply be copied and put under another distribution license [including the GNU Public License.] END OF SCHEDULE 3-C Software End User License Agreement Wireless-N Access Point with Dual-Band 3425-01410 09060310NC-AI 38
  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
USER GUIDE
Wireless-N Access Point
with Dual-Band
Model:
WAP610N