Compaq 245161-B22 HP 10000 Series Rack Airflow Optimization Kit Installation I
Compaq 245161-B22 - 10642 42U Rack Shock Pallet Manual
UPC - 720591208066
View all Compaq 245161-B22 manuals
Add to My Manuals
Save this manual to your list of manuals |
Compaq 245161-B22 manual content summary:
- Compaq 245161-B22 | HP 10000 Series Rack Airflow Optimization Kit Installation I - Page 1
to change without notice. The only warranties for HP products and services are set forth in the express warranty statements accompanying such products and services. Nothing herein should be construed as constituting an additional warranty. HP shall not be liable for technical or editorial errors - Compaq 245161-B22 | HP 10000 Series Rack Airflow Optimization Kit Installation I - Page 2
rail gasket must be installed into the rack before two or more racks can be bayed together. For additional information on baying racks, see the HP Baying Rack Option Kit. If installing the foam rail gasket between racks that have a baying kit installed, the baying bracket must be removed before the - Compaq 245161-B22 | HP 10000 Series Rack Airflow Optimization Kit Installation I - Page 3
2. Remove the protective tape from the bottom edge of the floor gasket, and apply it to the bottom of the rack with the adhesive strip facing the front of the rack. Installation is complete.
HP 10000 Series Rack Airflow
Optimization Kit
Installation Instructions
Overview
The HP 10000 Series Rack Airflow Optimization Kit enables you to
install foam rail gaskets into your HP 10000 G2 Series 22U, 36U,
42U, and 47U 600-mm (24 in) wide racks and into 42U 800-mm
(31 in) wide racks to improve separation between hot and cold
aisles in the data center.
Kit contents
Callout
Description
1
600-mm (24 in) or 800-mm (31 in) perforated
floor gasket (1)
2
Foam rail gasket roll (4)
Installing foam rail gaskets
IMPORTANT:
This option kit is only compatible with HP
racks that are 600-mm (24 in) or 800-mm (31 in) wide.
1.
Cut the foam rail gasket to fit the size of your rack.
2.
Insert the foam rail gasket into the rack front door on both sides
of the rack.
3.
Insert the foam rail gasket into the space between the 19-in
mounting rails and the vertical frame on both sides of the rack,
with the closed cell side of the foam rail gasket facing the front
of the rack.
© Copyright 2002, 2007 Hewlett-Packard Development Company, L.P.
The information contained herein is subject to change without notice. The only
warranties for HP products and services are set forth in the express warranty
statements accompanying such products and services. Nothing herein should
be construed as constituting an additional warranty. HP shall not be liable for
technical or editorial errors or omissions contained herein.
Part Number 302980-003
July 2007 (Third Edition)