Compaq 284688-B21 3X-KZPEA Release Notes, June 2006

Compaq 284688-B21 - HP StorageWorks SCSI Adaper Storage Controller U160 160 MBps Manual

Get Compaq 284688-B21 - HP StorageWorks SCSI Adaper Storage Controller U160 160 MBps PDF manuals and user guides
UPC - 613326436721
View all Compaq 284688-B21 manuals
Add to My Manuals
Save this manual to your list of manuals

Compaq 284688-B21 manual content summary:

  • Compaq 284688-B21 | 3X-KZPEA Release Notes, June 2006 - Page 1
    Adapter Module Be sure to read these notes and the provided User Guide before installing the KZPEA-DB Ultra 160 SCSI Storage Adapter Module into your PCI based host AlphaServer system. The module supports both 32 and 64 bit PCI slots. Note: The KZPEA supports SCSI bus speeds up to Ultra3 160MB/sec
  • Compaq 284688-B21 | 3X-KZPEA Release Notes, June 2006 - Page 2
    AlphaServer System XP900 XP1000 DS10 DS10L DS15 DS20E DS20L DS25 ES40 ES45 GS803 GS1603 GS3203 ES47 Tower ES474 ES805 GS1280 Number of Adapters Supported 1 1 1 1 2 4 1 4 4 6 4 4 4 24 24 24 32 Minimum Revision Operating System Required V5.1 with Patch Kit 31 V5.1 with Patch Kit 31 V5.1 with Patch
  • Compaq 284688-B21 | 3X-KZPEA Release Notes, June 2006 - Page 3
    V6.9 V6.9 V6.9 Tru64 UNIX Shared Tape See page 15 for information about shared tape support. Supported AlphaServer System DS10 DS15 DS20E DS25 ES40 ES45 ES47 ES80 GS1280 Number of Adapters Supported 1 2 4 4 4 6 6 6 6 Minimum Revision Operating System Required V5.1B-2/PK4 V5.1B-2/PK4 V5.1B-2/PK4
  • Compaq 284688-B21 | 3X-KZPEA Release Notes, June 2006 - Page 4
    -V0100 The latest TIMA kits can be obtained from the following FTP site: ftp://ftp.itrc.hp.com/openvms_patches/alpha/ • ES40 support is only with EV68 systems. There is no ES40 support for EV6 or EV67 systems. • DS20E systems must have one of the following specific part numbers: DA-56PAB-DA/EA
  • Compaq 284688-B21 | 3X-KZPEA Release Notes, June 2006 - Page 5
    JPN2 MSA30 S-B ALL MSA30 D-B ALL MSA30 4Port HPUX/IA64 LinuxJBO Note: The MSA30 shelves (3R-A4075-AA and 3R-A4076-AA) are not supported in shared bus configurations. 2. The following disk drives have a minimum required firmware version for use in a shared KZPEA SCSI bus configuration: Bare Drive
  • Compaq 284688-B21 | 3X-KZPEA Release Notes, June 2006 - Page 6
    will list the Product ID and the drive firmware revision. 3. For KZPEA use in GS80/GS160/GS320 AlphaServers (dual-bus shelves only are supported) and for all other AlphaServer platforms with single bus shelves, the KZPEA configurations must not include any disk drives having Arbitration Fairness
  • Compaq 284688-B21 | 3X-KZPEA Release Notes, June 2006 - Page 7
    reference their specific platform's Supported Options List at the following URL for additional information on supported devices. http://h18002.www1. PBXGK-BB13 SN-PBXGF-AB13 3X-PBXGG-AA Refer to the KZPEA User Guide regarding the board's SCSI configuration options and their settings. 10 PCI buses
  • Compaq 284688-B21 | 3X-KZPEA Release Notes, June 2006 - Page 8
    on the KZPEA board. Version 6.1 and later of the SRM console will only support using the "run bios pk *0" method of setting the host SCSI ID on increase or decrease in SCSI bus transfer speed, depending on the device. A problem would occur using the KZPEA controller if you were using a SCSI-2 storage
  • Compaq 284688-B21 | 3X-KZPEA Release Notes, June 2006 - Page 9
    the "SCSI Termination" paragraph under section 2.1.2 of the KZPEA User Guide which states that the adapter can only be located at the end internal bus lengths. The y-cables are 0.7 meters each. The following cables are supported in the shared bus configuration: 2-5-2 P/N 3X-BC56J-02 3X-BC56J-03 3X-
  • Compaq 284688-B21 | 3X-KZPEA Release Notes, June 2006 - Page 10
    the "SCSI Termination" paragraph under section 2.1.2 of the KZPEA User Guide which states that the adapter can only be located at the end and greater do not have this restriction. Required Components for Shared SCSI Bus Support (per shared bus) for Configuration B 2-5-2 P/N 3X-H8411-AA 3X-BN56A-
  • Compaq 284688-B21 | 3X-KZPEA Release Notes, June 2006 - Page 11
    cables (signal cable to the storage shelf and terminator cable between nodes) as well as KZPEA and shelf internal bus lengths. The following cables are supported in the shared bus configuration: Signal cables between the mid-node and the storage shelf: 2-5-2 P/N 3X-BC56J-02 3X-BC56J-03 3X-BC56J-04
  • Compaq 284688-B21 | 3X-KZPEA Release Notes, June 2006 - Page 12
    the procedure to disable on-board termination, and also to change one of the adapter's SCSI ID to 6. Refer to the system and KZPEA User's Guides for proper system shutdown, power off and ESD protections. 1) Disconnect any attached cables and remove the on board termination jumper for the bus being
  • Compaq 284688-B21 | 3X-KZPEA Release Notes, June 2006 - Page 13
    with the SCSI Configuration Utility. Refer to the KZPEA User's Guide regarding operation of the adapter's onboard SCSI Configuration Utility. Termination 1B w/pk4 (5.1B2/TCR V5.1B-2) Required Components for Shared SCSI Bus Support (per shared bus) for Configuration C 2-5-2 P/N 3X-H8511-AA Qty
  • Compaq 284688-B21 | 3X-KZPEA Release Notes, June 2006 - Page 14
    the procedure to enable on-board termination, and also to change one of the adapter's SCSI ID to 6. Refer to the system and KZPEA User's Guides for proper system shutdown, power off and ESD protections. 1) Disconnect any attached cables and install the on board termination jumper for the bus being
  • Compaq 284688-B21 | 3X-KZPEA Release Notes, June 2006 - Page 15
    drive between two systems under Tru64 UNIX. Only specific tape drives are supported in the shared bus environment as listed below: HP StorageWorks SDLT 320 the "SCSI Termination" paragraph under section 2.1.2 of the KZPEA User Guide which states that the adapter can only be located at the end of
  • Compaq 284688-B21 | 3X-KZPEA Release Notes, June 2006 - Page 16
    internal SCSI connector associated with that bus for each KZPEA adapter. SCSI Cabling Considerations for Shared Bus Support with Configuration A The maximum LVD bus length for KZPEA shared SCSI bus support is 12 meters (39 feet). This includes the combined length of the two y-cables and the two
  • Compaq 284688-B21 | 3X-KZPEA Release Notes, June 2006 - Page 17
    the "SCSI Termination" paragraph under section 2.1.2 of the KZPEA User Guide which states that the adapter can only be located at the end of tape drive. Note: In Configuration B only SCSI Channel 2/B on the KZPEA is supported for shared bus use with the SDLT 600 or the Ultrium 448 tape drives.
  • Compaq 284688-B21 | 3X-KZPEA Release Notes, June 2006 - Page 18
    . Required Components for Shared SCSI Bus Support (per shared bus) for Configuration B 2-5-2 P/N 3X-H8411-AA 3X-BN56A-03 3X-BN56A-04 Qty. -04 Description 3M TERM SCSI CABLE 4M TERM SCSI CABLE Figure 5 is an example of a Configuration B supported KZPEA shared SCSI bus configuration. 18
  • Compaq 284688-B21 | 3X-KZPEA Release Notes, June 2006 - Page 19
    the procedure to disable on-board termination, and also to change one of the adapter's SCSI ID to 6. Refer to the system and KZPEA User's Guides for proper system shutdown, power off and ESD protections. 1) Disconnect any attached cables and remove the on board termination jumper for the bus being
  • Compaq 284688-B21 | 3X-KZPEA Release Notes, June 2006 - Page 20
    contained herein is subject to change without notice. The only warranties for HP products and services are set forth in the express warranty statements accompanying such products and services. Nothing herein should be construed as constituting an additional warranty. HP shall not be liable
  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
3X-KZPEA Release Notes
June 2006
EK-KZPEA-RN.
G01
KZPEA-DB Ultra 160 64-Bit PCI–SCSI Dual Channel Storage Adapter Module
Be sure to read these notes and the provided User Guide before installing the KZPEA-DB Ultra 160 SCSI
Storage Adapter Module into your AlphaServer.
Note:
Please refer to the latest version of these release notes, which can be found on the KZPEA Web
Page.
The KZPEA web page can be accessed by clicking on the appropriate link on the HP
AlphaServer storage options page at the following URL:
The KZPEA-DB Ultra 160 SCSI Storage Adapter is a very high performance PCI option module that
connects devices attached to its two 16-bit Ultra3 160MB/s LVD/SE SCSI ports to a PCI based host
AlphaServer system. The module supports both 32 and 64 bit PCI slots.
Note:
The KZPEA supports SCSI bus speeds up to Ultra3 160MB/sec when using LVD signaling
(requiring multi-mode or LVD only terminators on the bus).
The fastest the adapter can run in SE
mode is UltraSCSI speeds.
This document describes any known issues or restrictions when using the KZPEA-DB Ultra 160 SCSI
Storage Adapter within your system configuration. This document contains four sections:
•
Parts List for the KZPEA-DB
•
Supported HP Systems
•
Restrictions and Notes
•
Shared Bus Support
KZPEA-DB Parts List
Part Number
Description
30-56150-03
PCB, PCI, 64bit/66MHz, U3 SCSI adapter module
EK-KZPEA-UG
KZPEA User’s Guide
EK-KZPEA-RN
Adapter release notes, this document
3R-Q00LA-3V
HP options warranty