Compaq 6000 Maintenance & Service Guide: HP Compaq 6000 Pro Microtower Bus - Page 161
Removing and Replacing the Primary 3.5-inch Internal SATA Hard Drive, Rotating the Drive Cage Up
UPC - 894582579463
View all Compaq 6000 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 161 highlights
Removing and Replacing the Primary 3.5-inch Internal SATA Hard Drive NOTE: The system does not support Parallel ATA (PATA) hard drives. Before you remove the old hard drive, be sure to back up the data from the old hard drive so that you can transfer the data to the new hard drive. The preinstalled 3.5-inch hard drive is located under the power supply. To remove and replace the hard drive: 1. Prepare the computer for disassembly (Preparation for Disassembly on page 122). 2. Remove the access panel (Access Panel on page 123). 3. Rotate the drive cage for external drives to its upright position. Figure 9-31 Rotating the Drive Cage Up Installing and Removing Drives 149
Removing and Replacing the Primary 3.5-inch Internal SATA Hard Drive
NOTE:
The system does not support Parallel ATA (PATA) hard drives.
Before you remove the old hard drive, be sure to back up the data from the old hard drive so that you
can transfer the data to the new hard drive.
The preinstalled 3.5-inch hard drive is located under the power supply. To remove and replace the hard
drive:
1.
Prepare the computer for disassembly (
Preparation for Disassembly
on page
122
).
2.
Remove the access panel (
Access Panel
on page
123
).
3.
Rotate the drive cage for external drives to its upright position.
Figure 9-31
Rotating the Drive Cage Up
Installing and Removing Drives
149