Compaq Evo n1050v Service Manual - Page 120
Removing the RJ11/1394 Connector Module, HP Pavilion 5300 and 5200, HP nx9010
View all Compaq Evo n1050v manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 120 highlights
3. Remove the four screws that secure the hard disk drive guide to the bottom case. Note The four screws that secure the hard disk drive guide are two different sizes. The screw in the upper left corner is a M2.5×6.0 mm screw. The remaining three screws are M2.0×4.0 mm screws. Make sure these screws are installed in the correct locations when reinstalling the hard disk drive guide. 4. Remove the hard disk drive guide. 5. Disconnect the modem cable from the motherboard. 6. Disconnect the 1394 cable from the motherboard. 7. Remove the M2.5×6.0 mm screw that secures the RJ11/1394 connector module to the bottom case. 8. Remove the RJ11/1394 connector module. Figure 2-30. Removing the RJ11/1394 Connector Module HP Pavilion 5300 and 5200, HP nx9010, and Compaq Presario 2500 Models Service Manual Removal and Replacement 2-49