Craftsman 17761 Owners Manual

Craftsman 17761 - 16 Gal. Wet-Dry VAC Manual

Get Craftsman 17761 - 16 Gal. Wet-Dry VAC PDF manuals and user guides View all Craftsman 17761 manuals
Add to My Manuals
Save this manual to your list of manuals

Craftsman 17761 manual content summary:

  • Craftsman 17761 | Owners Manual - Page 1
    may be found on the handle. You should record both model and serial numbers in a safe )lace for future use. FOR YOUR SAFETY READ ALL INSTRUCTIONS CAREFULLY CRRFTSHRN 16 GALLON WET/DRY VAC • assembly • operating • repair parts J Sears, Roebuck and Co., Hoffman Estates, IL 60179
  • Craftsman 17761 | Owners Manual - Page 2
    of personal injury or damage to Wet/Dry Vac, use only Sears Craftsman recommended accessories. Do not use this Wet/Dry Vac with a torn filter or without the filter installed except when vacuuming liquids as described in the operation section of this manual. Sparks inside the motor can ignite
  • Craftsman 17761 | Owners Manual - Page 3
    the motor housing of your Wet/Dry Vac. I_ GOROUBULNED INNSOUTLARTEEQDU-IRED WHEN SERVICING USE ONLY IDENTICAL REPLACEMENT PARTS WARNING: To reduce the risk of electric shock - do not expose to rain - store indoors. WARNING: For your own safety, read and understand owner's manual. Do not pick up
  • Craftsman 17761 | Owners Manual - Page 4
    Qty. Vac Assembly Pos-I-Lock Hose Assembly Utility Nozzle Wet Nozzle Car Nozzle Filter Nut Filter Plate 1 ...1 1 1 1 1 1 Filter (Red Stripe) .......... 1 Filter Cage 1 Float 1 Extension Wands ........... 2 Caster Foot W/Storage ...... 4 Caster 4 Owners Manual 1 Carton
  • Craftsman 17761 | Owners Manual - Page 5
    safety and operation instructions. Do not operate vac with any parts damaged or missing. 1.Carefully slide the filter over the filter cage, sliding the filter plate, filter cage, or filter. NOTE: Your filter has a red stripe that matches an in-store displayer. When you visit your local Sears store,
  • Craftsman 17761 | Owners Manual - Page 6
    the socket and the caster will swivel easily when positioning is correct. 7. Turn the drum upright. Drum Vac Assembly 1. Line up front (label and switch side) of power assembly with drain cap and vac port located on the front of the drum. Note: Power assembly must be aligned with drum for proper
  • Craftsman 17761 | Owners Manual - Page 7
    ) Cord Wrap The wet/dry vac has a convenient cord wrap area designed on the rear of the vac. Simply, wrap the power cord around the the "Pos-ILock" hose into the inlet of the vac. The hose should snap into place. To remove the hose from the vac, press the release button in the hose assembly and pull
  • Craftsman 17761 | Owners Manual - Page 8
    3. If your filter is wet but you need to use the vac to pick up dry material, you can quickly dry the filter by running the vac without hose attached for about 10 minutes. The clean air rushing through the vac will help dry the filter. The optional Craftsman HEPA Rated Material Filter, stock number
  • Craftsman 17761 | Owners Manual - Page 9
    to opposite end of hose, then place the car nozzle on the wand. 4.Turn vac on and you are ready to use your vac as a blower. Sears recommended accessories are available at Sears retail stores. The Sears Blower Nozzle Stock No. 9-16933 is recommended for blowing debris. Push/Pull Handle - Locking
  • Craftsman 17761 | Owners Manual - Page 10
    filter to dry before storing the vac. Wet/Dry Vac To keep your Wet/Dry Vac looking its best, clean the outside with a cloth dampened with warm water and mild soap. To clean the drum: I WARNING: To assure product SAFETY and RELIABILITY, repairs and adjustment should be performed by Sears Service
  • Craftsman 17761 | Owners Manual - Page 11
    surface as you vacuum. Replacement rubber for the squeegee nozzle may be obtained through Sears Parts. If the rubber becomes worn, it may be flipped over for use on the opposite side or replaced. (Replacement service part #822256). To reverse or replace the squeegee: 1. Lay the wet nozzle on a flat
  • Craftsman 17761 | Owners Manual - Page 12
    and knowledge of the system, and should be done only by qualified service personnel. Replacement parts for a double-insulated Wet/Dry Vac must be identical to the parts they replace. Your double-insulated Wet/Dry Vac is marked with the words "DOUBLE INSULATED" and the symbol _ (square within
  • Craftsman 17761 | Owners Manual - Page 13
    Repair Parts 16 Gallon Wet/Dry Vac Model Number 113.177610 16 18 19 21,_ 20 13
  • Craftsman 17761 | Owners Manual - Page 14
    Notes 14
  • Craftsman 17761 | Owners Manual - Page 15
    Notes 15
  • Craftsman 17761 | Owners Manual - Page 16
    numbers will be found on the handle. When requesting service or ordering following information: • Product Type • Part Number • Model Number • Part Description parts, always provide the 2003 Emerson Sears, Roebuck and Co., Chicago, IL 60179 U.S.A. Part No. SP6502 Form No. SP6502-1 Printed in
  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
Save
This
Manual
For
Future
Reference
S£A_RS
owner's
manual
MODEL
NO.
113.17761q
Serial
Number
Model
and serial
numbers
may
be
found
on the
handle.
You should
record
both model
and serial
numbers
in a safe
)lace for future
use.
FOR YOUR
SAFETY
READ ALL
INSTRUCTIONS
CAREFULLY
J
CRRFTSHRN
16 GALLON
WET/DRY
VAC
•
assembly
•
operating
•
repair parts
Sears,
Roebuck
and
Co., Hoffman
Estates,
IL 60179
U.S.A.
Part
No.
SP6502
Printed in
U,S.A.