Craftsman 27233 Operation Manual
Craftsman 27233 - Professional Electric Brad Nailer Manual
 |
View all Craftsman 27233 manuals
Add to My Manuals
Save this manual to your list of manuals |
Craftsman 27233 manual content summary:
- Craftsman 27233 | Operation Manual - Page 1
Owner's Manual ELECTRIC NAILER Model No. 836.272330 Serial No. NOTE: Model and serial numbers may be found on the name plate located on the tool. You should record both numbers and retain them in a safe place. CitAs USTaIfOetNy: RuBlefsoraendusOinpgertahtiisngNailnesr,trurcetaiodntsh.is manual and - Craftsman 27233 | Operation Manual - Page 2
Warranty Product Specifications Safety Instructions Accessories and Attachments Know Your Brad Nailer Operation Maintenance Troubleshooting Guide Parts PAGE 2 2 3 6 7 7 8 9 10 FULL ONE YEAR WARRANTY ON CRAFTSMAN PROFESSIONAL ELECTRIC NAILER If this Craftsman Nailer fails due to a defect - Craftsman 27233 | Operation Manual - Page 3
. Failure to comply can result in accidents involving fire, electric shock, or serious personal injury. Save this owner's manual and review it frequently for continuing safe operation and instructing possible third-party users. READ ALL INSTRUCTIONS 1. KEEP WORK AREA CLEAN. Cluttered work areas and - Craftsman 27233 | Operation Manual - Page 4
servicing and when loading or changing accessories. 14.AVOID UNINTENTIONAL STARTING. Never carry tool with your finger on the switch. 15 authorized Sears service facility. servicing, use only identical replacement parts ordered from a Sears service in good electrical condition. Always Sears. NOTE: - Craftsman 27233 | Operation Manual - Page 5
, if the nailer starts to feel hot, discontinue use until the unit cools down, GROUNDING INSTRUCTIONS 1. USE ONLYTHE NAILS INDICATED in this manual. Use of REPLACE DAMAGED OR WORN CORD IMMEDIATELY, if repair or replacement of the electric cord or plug is ever necessary. DO NOT connect the equipment- - Craftsman 27233 | Operation Manual - Page 6
frames Door & window trim NOTE: Use only brad nails recommended for this nailer. Using other sizes may be dangerous. Sears may recommend other accessories not listed in this manual. Do not use accessories unless you have completely read the instruction manual for that accessory. Do not attempt to - Craftsman 27233 | Operation Manual - Page 7
-Housing Safety lock pin Trigger switch cord t g mouth Latch Nail magazine HOW TO LOAD YOUR BRAD NAILER (FIGURE 1) 1. Unplug nailer from power source. 2. Use only brad nails recommended; see brad nail chart. 3. Push up the latch (1) toward the magazine and slide out the magazine (2). 4. Position - Craftsman 27233 | Operation Manual - Page 8
drive the brad nail. 5. If the workpiece is very hard, press down on the housing cap (4) with _ L _ your free hand. _._ NOTE: AVOID BLANK SHOTS to prevent wear and damage to internal parts. /// k_ k _'_" _ J 1 _'_ 1 J I /J I/ 2 The nailer must be disconnected from the electrical power - Craftsman 27233 | Operation Manual - Page 9
PROBABLE CAUSE Nailer will net fire 1. Not plugged in 2. Circuit breaker tripped 3. Damaged cord Nail jammed 1. Dirty, rusty, or deformed nails 2. Incorrect nails Power loss 1. Damaged coil spring REMEDY 1, Plug in 2. Reset circuit breaker or fuse 3. Have replaced by Sears Service Center - Craftsman 27233 | Operation Manual - Page 10
ELECTRIC BRAD NAILER MODEL NUMBER 836,27233 Key Number Order by PART NUMBER, not by key number Part Number Description 1 spring 10 DAA0320060 Safety lock pin (Guide bar) 1t 2723301 Screwdriver 12 2723302 Carry case 13 2723303 Owner's manual 14 2723304 Hex Key Page 10 - Craftsman 27233 | Operation Manual - Page 11
13 - Craftsman 27233 | Operation Manual - Page 12
For information on purchasing a Sears A Maintenance Agreement or to inquire about an existing Agreement Call 9 am - 5 pm, Monday-Saturday 1-800-827-6655 The model number of your product is located on the name plate on the front of the Electric Nailer, When requesting service or ordering parts
-
1 -
2 -
3 -
4 -
5 -
6 -
7 -
8
-
9
-
10
-
11
-
12
 |
 |
2723303
Owner's Manual
ELECTRIC
NAILER
Model
No.
836.272330
Serial
No.
NOTE:
Model and serial numbers
may be found on the name plate
located on the tool.
You should
record
both numbers
and retain them in a safe place.
CAUTION:
Before
using this
Nailer,
read this manual and follow all
its Safety
Rules
and
Operating
instructions.
E185030
Sears,
Roebuck
and
Co.,
Hoffman
Estates,
IL 60179
USA