Home » Cub Cadet Manuals » Lawn Mowers » Cub Cadet PRO Z 148S EFI » Manual Viewer

Cub Cadet PRO Z 148S EFI Owners Manual

Cub Cadet PRO Z 148S EFI Manual

View all Cub Cadet PRO Z 148S EFI manuals

Add to My Manuals
Save this manual to your list of manuals

Cub Cadet PRO Z 148S EFI manual content summary:

Cub Cadet PRO Z 148S EFI | Owners Manual - Page 1
Manual Zero-Turn Rider Pro Z 100 Steering Wheel Table of Contents Safe Operation Practices 2 Assembly & Set-Up 10 Controls & Operation 13 Service 18 Troubleshooting 24 Replacement Parts 25 Attachments & Accessories 25 Warranties 26 WARNING READ AND FOLLOW ALL SAFETY RULES AND INSTRUCTIONS
Cub Cadet PRO Z 148S EFI | Owners Manual - Page 2
instructions in this manual before attempting to operate this machine. Failure to comply with these instructions is used, it should be maintained in effective working order by the operator. In the state of your nearest engine authorized service dealer or contact the service department, P.O. Box
Cub Cadet PRO Z 148S EFI | Owners Manual - Page 3
safety signs. 3. All operators and mechanics should be trained to operate or service the equipment. The owner is responsible for training them. 4. Never let , and follow all instructions on the machine and in the manual(s) before attempting to assemble and operate. Keep this manual in a safe place
Cub Cadet PRO Z 148S EFI | Owners Manual - Page 4
machine by the machine manufacturer. Read, understand and follow all instructions provided with the approved accessory or attachment. 32. Data which are not covered in this manual use care and good judgement. Contact your customer service representative for assistance. Slope Operation Slopes
Cub Cadet PRO Z 148S EFI | Owners Manual - Page 5
machine. Children 16 and over should read and understand the about the operator's waist at all times, except when the instructions and safe operation practices in this manual and on ROPS are: the machine and should be trained and supervised by an adult. a. Not properly installed and/or
Cub Cadet PRO Z 148S EFI | Owners Manual - Page 6
gloves and safety glasses. Safely relieve all pressure in the system before performing any work on the system, and make sure that: • The ignition switch is OFF • described later in this manual. If the safety interlock system does not function properly, have your machine serviced. 6. Check brake
Cub Cadet PRO Z 148S EFI | Owners Manual - Page 7
may also include a carbon canister. Please contact Customer Support for information regarding the evaporative emission control configuration for your follow the warnings and instructions in this manual and on the machine. SAVE THESE INSTRUCTIONS! Section 2 - Important Safe Operation Practices
Cub Cadet PRO Z 148S EFI | Owners Manual - Page 8
on the machine before attempting to assemble and operate. Symbol Description READ THE OPERATOR'S MANUAL(S) Read, understand, and follow all instructions in the manual(s) before attempting to assemble and operate WARNING - ROTATING BLADES Do not put hands or feet near rotating parts or
Cub Cadet PRO Z 148S EFI | Owners Manual - Page 9
9 Slope Gauge Section 2 - Safe Operation Practices (OK) Figure 1 20° (35%) Slope (TOO STEEP) Figure 2 20° (35%) dashed line USE THIS SLOPE GAUGE TO DETERMINE IF A SLOPE IS TOO STEEP FOR SAFE OPERATION! To check the slope, proceed as follows: 1. Remove this page and fold along the dashed line.
Cub Cadet PRO Z 148S EFI | Owners Manual - Page 10
. Please read this entire manual prior to operating the equipment. It instructs you how to safely and problems or questions concerning the machine, phone your local authorized service dealer or contact us directly. We want to ensure your complete satisfaction at all times. Throughout this manual
Cub Cadet PRO Z 148S EFI | Owners Manual - Page 11
over the positive battery terminal to help protect it from corrosion. NOTE: If the battery is put into service after the date shown on top/side of battery, charge the battery as instructed in "Charging the Battery" on page 23 prior to operating the tractor. Transmission Oil Expansion Reservoir The
Cub Cadet PRO Z 148S EFI | Owners Manual - Page 12
Install the Rear Hitch Bracket (If necessary) 1. Remove the hex flange screws (a) and flange lock nuts (b) that secure the hitch bracket (c) to the bumper bracket. See Figure 2-10. c a b a a b b Figure 2-10 2. Install the hitch bracket (c) as shown in Figure 2-11 and secure with the hex flange
Cub Cadet PRO Z 148S EFI | Owners Manual - Page 13
LH Transmission Bypass Rod RH Transmission Bypass Rod * - If Equipped + - Optional NOTE: This Operator's Manual covers several models. Tractor features may vary by model. Not all features in this manual are applicable to all tractor models and the tractor depicted may differ from yours. NOTE
Cub Cadet PRO Z 148S EFI | Owners Manual - Page 14
engine will automatically shut off. Control Panel PTO Switch (a) The PTO (Power Take-Off) switch is located on the RH console service minder interval will occur every 50 hours. Before the interval expires, change the engine oil as instructed in the Maintenance section of this Operator's Manual
Cub Cadet PRO Z 148S EFI | Owners Manual - Page 15
PTO and engage the parking brake, shut off the engine and remove the ignition key. Wait for all movement to stop before servicing operate the tractor. Contact your Cub Cadet dealer. • The safety interlock level. Refer to the Engine Operator's manual for instructions on checking the engine oil level.
Cub Cadet PRO Z 148S EFI | Owners Manual - Page 16
possible. 3. Start the disabled tractor following the normal starting instructions previously provided; then disconnect the jumper cables in the exact WARNING! Do not leave the seat of the tractor without first placing the PTO knob in the disengaged (OFF) position and engaging the parking brake. If
Cub Cadet PRO Z 148S EFI | Owners Manual - Page 17
when lowered in grass. Premature wear and possible failure of the 'V" belt and PTO clutch will result. Fully raise the deck or move to a non grassy across slopes, not up and down. If mowing a slope, start at bottom and work upward to ensure turns are made uphill. 2. On the first pass pick a point
Cub Cadet PRO Z 148S EFI | Owners Manual - Page 18
Cub Cadet 251H EP grease after every 10 hours of service. • Periodically lubricate all other pivot points with a quality lubricating oil. Engine Refer to the Engine Operator's Manual for all engine maintenance intervals, procedures, specifications and instructions , always disengage PTO, set parking
Cub Cadet PRO Z 148S EFI | Owners Manual - Page 19
or seriously under inflated. Have it inspected and serviced by a qualified tire mechanic. Battery Information WARNING eyes and protect skin and clothing when working near batteries. • Batteries contain sulfuric bypass rod that will allow you to manually move the tractor short distances. WARNING! Do
Cub Cadet PRO Z 148S EFI | Owners Manual - Page 20
problems. 20 Section 4- Service b. Use a fuel stabilizer for storage between 30 and 90 days: • Read the product manufacturer's instructions all fuel in the carburetor has been exhausted. • Referring to the engine manual, drain the fuel from the carburetor bowl. 3. Clean the engine and the
Cub Cadet PRO Z 148S EFI | Owners Manual - Page 21
fuel fumes may reach an open flame, spark or pilot light as on a furnace, water heater, clothes dryer, etc. 2. Service the engine as instructed in the separate Engine Operator's Manual. 3. Engines stored between 30 and 90 days need to be treated with a gasoline stabilizer and engines stored over 90
Cub Cadet PRO Z 148S EFI | Owners Manual - Page 22
problem with blown fuses, have the tractor's electrical system checked by your Cub Cadet Service Dealer See Figure 4-2. (b) (a) (c) Figure 4-2 b. Working from the middle of the tractor, pivot the the PTO pulley. c. Pull the left side of the belt rearward and downward while manually turning the PTO
Cub Cadet PRO Z 148S EFI | Owners Manual - Page 23
the tractor frame, above the transmission tube(s), to the PTO pulley on the bottom of the engine. 8. Using by using heavy gloves when handling the blades. When servicing the mower deck, be careful not to cut yourself transmission drive belt. See your Cub Cadet dealer to have the transmission drive
Cub Cadet PRO Z 148S EFI | Owners Manual - Page 24
Troubleshooting Problem Excessive vibration Uneven cut Mower will not mulch grass (If Equipped w/Mulching Kit) Cause 1. Cutting blade loose or unbalanced. 2. Damaged or bent cutting blade. 1. Deck
Cub Cadet PRO Z 148S EFI | Owners Manual - Page 25
Oil Filter Wrench Armortek Non-Stick Spray Carburetor & Choke Cleaner Description Phone (800) 965-4CUB to order replacement parts or a complete Parts Manual (have your full model number and serial number ready). Parts Manual downloads are also available free of charge at www.cubcadet.com. 25
Cub Cadet PRO Z 148S EFI | Owners Manual - Page 26
manual problem exists. The warranty repairs should be completed in a reasonable amount of time, not to exceed 30 days. If you have a question regarding your warranty coverage, you should contact the MTD Consumer Group Inc Service Department at 1-800-800-7310 or at http://support written instructions
Cub Cadet PRO Z 148S EFI | Owners Manual - Page 27
WARRANTED PARTS: The repair or replacement of any warranted part otherwise eligible for warranty coverage may be excluded from such warranty coverage if MTD Consumer Group Inc demonstrates that the outdoor equipment has been abused, neglected, or improperly maintained, and that such abuse, neglect,
Cub Cadet PRO Z 148S EFI | Owners Manual - Page 28
CUB CADET LLC MANUFACTURER'S LIMITED WARRANTY FOR PRO Z 100 COMMERCIAL ZERO-TURN RIDING MOWERS IMPORTANT: To obtain warranty coverage owner must present an original proof of purchase and applicable maintenance records to the servicing dealer. Please see the operator's manual for information on