Cub Cadet 524 SWE Two-Stage Snow Thrower 524 WE Operator's Manual - Page 19
Service
View all Cub Cadet 524 SWE Two-Stage Snow Thrower manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 19 highlights
Service 7 Belt Replacement Auger Belt To remove and replace your snow thrower's auger belt, proceed as follows: 4. Carefully pivot the snow thrower up and forward so that it rests on the auger housing. 5. Remove the frame cover from the underside of the snow thrower by removing the self-tapping screws which secure it. See Figure 7-3. 1. Allow the engine to run until it is out of fuel. Do not attempt to pour fuel from the engine. 2. Remove the plastic belt cover on the front of the engine by removing the two self-tapping screws. See Figure 7-1. Figure 7-1 3. Roll the auger belt off the engine pulley. See Figure 7-2. Figure 7-3 6. Remove the belt as follows: a. Loosen and remove the shoulder bolt which acts as a belt keeper. b. Unhook the auger brake bracket spring from the frame. See Figure 7-4. Figure 7-2 Figure 7-4 19