D-Link DES-3828 Product Manual - Page 123
Link Aggregation Commands, create link_aggregation - d link xstack
UPC - 790069276811
View all D-Link DES-3828 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 123 highlights
xStack DES-3800 Series Layer 3 Stackable Fast Ethernet Managed Switch CLI Manual 16 LINK AGGREGATION COMMANDS The link aggregation commands in the Command Line Interface (CLI) are listed (along with the appropriate parameters) in the following table. Command create link_aggregation group_id delete link_aggregation group_id config link_aggregation group_id config link_aggregation algorithm show link_aggregation Parameters {type [lacp | static]} {master_port | ports state [enable | disable]} [mac_source | mac_destination | mac_source_dest | ip_source | ip_destination | ip_source_dest] {group_id | algorithm} Each command is listed, in detail, in the following sections. create link_aggregation Purpose Syntax Description Parameters Restrictions Used to create a link aggregation group on the Switch. create link_aggregation group_id {type [lacp | static]} This command will create a link aggregation group with a unique identifier. − Specifies the group ID. The Switch allows up to 32 link aggregation groups to be configured. The group number identifies each of the groups. type - Specify the type of link aggregation used for the group. If the type is not specified the default type is static. • lacp - This designates the port group as LACP compliant. LACP allows dynamic adjustment to the aggregated port group. LACP compliant ports may be further configured (see config lacp_ports). LACP compliant must be connected to LACP compliant devices. • static - This designates the aggregated port group as static. Static port groups can not be changed as easily as LACP compliant port groups since both linked devices must be manually configured if the configuration of the trunked group is changed. If static link aggregation is used, be sure that both ends of the connection are properly configured and that all ports have the same speed/duplex settings. Only Administrator or Operator-level users can issue this command. Example usage: To create a link aggregation group: DES-3800:admin#create link_aggregation group_id 1 Command: create link_aggregation group_id 1 Success. DES-3800:admin# 119