D-Link DES-3828 Product Manual - Page 141

xStack DES-3800 Series Layer 3 Stackable Fast Ethernet Managed Switch CLI Manual config 802.1x auth_parameter Purpose Syntax Description Parameters Restrictions Used to configure the 802.1x authentication parameters on a range of ports. The default parameter will return all ports in the specified range to their default 802.1x settings. config 802.1x auth_parameter ports [ | all] [default | {direction [both | in] | port_control [force_unauth | auto | force_auth] | quiet_period | tx_period | supp_timeout | server_timeout | max_req | reauth_period | enable_reauth [enable | disable]}] The config 802.1x auth_parameter command is used to configure the 802.1x Authentication parameters on a range of ports. The default parameter will return all ports in the specified range to their default 802.1x settings. − Specifies a port or range of ports to be configured. all − Specifies all of the ports on the Switch. default − Returns all of the ports in the specified range to their 802.1x default settings. direction [both | in] − Determines whether a controlled port blocks communication in both the receiving and transmitting directions, or just the receiving direction. port_control − Configures the administrative control over the authentication process for the range of ports. The user has the following authentication options: • force_auth − Forces the Authenticator for the port to become authorized. Network access is allowed. • auto − Allows the port's status to reflect the outcome of the authentication process. • force_unauth − Forces the Authenticator for the port to become unauthorized. Network access will be blocked. quiet_period − Configures the time interval between authentication failure and the start of a new authentication attempt. tx_period - Configures the time to wait for a response from a supplicant (user) to send EAP Request/Identity packets. supp_timeout - Configures the time to wait for a response from a supplicant (user) for all EAP packets, except for the Request/Identity packets. server_timeout - Configure the length of time to wait for a response from a RADIUS server. max_req − Configures the number of times to retry sending packets to a supplicant (user). reauth_period − Configures the time interval between successive re-authentications. enable_reauth [enable | disable] − Determines whether or not the Switch will re-authenticate. Enabled causes re-authentication of users at the time interval specified in the Re-authentication Period field, above. Only Administrator or Operator-level users can issue this command. Example usage: To configure 802.1x authentication parameters for ports 1 - 20: DES-3800:admin#config 802.1x auth_parameter ports 1-20 direction both Command: config 802.1x auth_parameter ports 1-20 direction both 137