D-Link DES-3828 Product Manual - Page 168

xStack DES-3800 Series Layer 3 Stackable Fast Ethernet Managed Switch CLI Manual 20 TRAFFIC SEGMENTATION COMMANDS Traffic segmentation allows you to further sub-divide VLANs into smaller groups of ports that will help to reduce traffic on the VLAN. The VLAN rules take precedence, and then the traffic segmentation rules are applied. Command config traffic_segmentation show traffic_segmentation Parameters forward_list [null | ] {} Each command is listed, in detail, in the following sections. config traffic_segmentation Purpose Syntax Description Parameters Restrictions Used to configure traffic segmentation on the Switch. config traffic_segmentation forward_list [null | ] The config traffic_segmentation command is used to configure traffic segmentation on the Switch. − Specifies a port or range of ports that will be configured for traffic segmentation. forward_list − Specifies a range of ports that will receive forwarded frames from the ports specified in the portlist, above. • null − No ports are specified • − Specifies a range of ports for the forwarding list. This list must be on the same Switch previously specified for traffic segmentation (i.e. following the specified above for config traffic_segmentation). Only Administrator or Operator-level users can issue this command. Example usage: To configure ports 1 through 10 to be able to forward frames to port 11 through 15: DES-3800:admin# config traffic_segmentation 1-10 forward_list 11-15 Command: config traffic_segmentation 1-10 forward_list 11-15 Success. DES-3800:admin# 164