D-Link DES-3828 Product Manual - Page 174
create ipif, config ipif, <vlan_name 32> | state [enable | disable] | proxy_arp [enable
UPC - 790069276811
View all D-Link DES-3828 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 174 highlights
xStack DES-3800 Series Layer 3 Stackable Fast Ethernet Managed Switch CLI Manual create ipif Restrictions interfaces can only be configured if a primary interface is first configured. proxy_arp [enable | disable] - Choose to enable or disable the proxy ARP for this IP interface. The Proxy ARP feature will allow this IP interface to reply to ARP requests destined for another interface by faking its identities the original ARP requester. The Switch is then capable of routing packets to the intended destination without configuring static routing or a default gateway. The default is disable. state [enable | disable] − Allows the user to enable or disable the IP interface. Only Administrator or Operator-level users can issue this command. Example usage: To create the primary IP interface, P1-1 on VLAN Trinity: DES-3800:admin#create ipif p1 ipaddress 10.1.1.1 Trinity state enable Command: create ipif p1 ipaddress 10.1.1.1 Trinity state enable Success. DES-3800:admin# To create the secondary IP interface, P1-1 on VLAN Trinity: DES-3800:admin#create ipif p1-1 ipaddress 12.1.1.1 Trinity secondary state enable Command: create ipif p1-1 ipaddress 12.1.1.1 Trinity secondary state enable Success. DES-3800:admin# config ipif Purpose Syntax Description Parameters Used to configure an IP interface set on the Switch. config ipif [{ipaddress | vlan | state [enable | disable] | proxy_arp [enable | disable]} | bootp | dhcp] This command is used to configure the System IP interface on the Switch. - Enter the previously created IP interface name desired to be configured. ipaddress − IP address and netmask of the IP interface to be configured. The address and mask information can be specified using the traditional format (for example, 10.1.2.3/255.0.0.0 or in CIDR format, 10.1.2.3/8). (This parameter may also appear as ). vlan − The name of the VLAN corresponding to the previously created IP interface. If a primary and secondary IP interface are configured for the same VLAN (subnet), the user cannot change the VLAN of the IP interface. state [enable | disable] − Allows users to enable or disable the IP interface. proxy_arp [enable | disable] - Choose to enable or disable the proxy 170