D-Link DES-3828 Product Manual - Page 201

xStack DES-3800 Series Layer 3 Stackable Fast Ethernet Managed Switch CLI Manual 29 DNS RELAY COMMANDS The DNS relay commands in the Command Line Interface (CLI) are listed (along with the appropriate parameters) in the following table. Command config dnsr enable dnsr disable dnsr show dnsr Parameters [[primary | secondary] nameserver | [add | delete] static ] {cache | static} {cache | static} {static} Each command is listed, in detail, in the following sections. config dnsr Purpose Syntax Description Parameters Restrictions Used to configure the DNS relay function. config dnsr [[primary | secondary] nameserver | [add | delete] static ] This command is used to configure the DNS relay function on the Switch. primary − Indicates that the IP address below is the address of the primary DNS server. secondary − Indicates that the IP address below is the address of the secondary DNS server. nameserver − The IP address of the DNS nameserver. [add | delete] - Indicates whether to add or delete the DNS relay function. − The domain name of the entry. − The IP address of the entry. Only Administrator or Operator-level users can issue this command. Example usage: To set IP address 10.43.21.12 of primary. DES-3800:admin#config dnsr primary 10.43.21.12 Command: config dnsr primary 10.43.21.12 Success DES-3800:admin# Example usage: To add an entry domain name dns1, IP address 10.43.21.12 to DNS static table: DES-3800:admin#config dnsr add static dns1 10.43.21.12 Command: config dnsr add static dns1 10.43.21.12 Success. DES-3800:admin# 197