D-Link DES-3828 Product Manual - Page 226

xStack DES-3800 Series Layer 3 Stackable Fast Ethernet Managed Switch CLI Manual config ospf ipif passive} Description This command is used to configure the OSPF interface settings. Parameters − The name of the IP interface. all - All IP interfaces. area - A 32-bit number in the form of an IP address (xxx.xxx.xxx.xxx) that uniquely identifies the OSPF area in the OSPF domain. priority − The priority used in the election of the Designated Router (DR). A number between 0 and 255. hello_interval − Allows the specification of the interval between the transmission of OSPF Hello packets, in seconds. Between 1 and 65535 seconds can be specified. The Hello Interval, Dead Interval, Authorization Type, and Authorization Key should be the same for all routers on the same network. dead_interval − Allows the specification of the length of time between the receipt of Hello packets from a neighbor router before the selected area declares that router down. An interval between 1 and 65535 seconds can be specified. The Dead Interval must be evenly divisible by the Hello Interval. metric − The interface metric (1 to 65535). Entering a 0 will allow automatic calculation of the metric. authentication - Enter the type of authentication preferred. The user may choose between: • none - Choosing this parameter will require no authentication. • simple − Choosing this parameter will set a simple authentication which includes a case-sensitive password of no more than 8 characters. • md5 − Choosing this parameter will set authentication based on md5 encryption. A previously configured MD5 key ID (1 to 255) is required. metric − This field allows the entry of a number between 1 and 65,535 that is representative of the OSPF cost of reaching the selected OSPF interface. The default metric is 1. state [enable | disable] - Used to enable or disable this function. active | passive - This parameter is used to assign the designated entry to be an active or passive interface. The default is active. Restrictions Only Administrator or Operator-level users can issue this command. Usage example: To configure OSPF interface settings: DES-3800:admin#config ospf ipif System priority 2 hello_interval 15 metric 2 state enable Command: config ospf ipif System priority 2 hello_interval 15 metric 2 state enable Success. DES-3800:admin# show ospf ipif Purpose Used to display the current OSPF interface settings for the specified interface name. 222