D-Link DES-3828 Product Manual - Page 318

xStack DES-3800 Series Layer 3 Stackable Fast Ethernet Managed Switch CLI Manual 45 DHCP RELAY The DHCP relay commands in the Command Line Interface (CLI) are listed (along with the appropriate parameters) in the following table. Command config dhcp_relay config dhcp_relay add ipif config dhcp_relay delete ipif config dhcp_relay option_82 state config dhcp_relay option_82 check config dhcp_relay option_82 policy show dhcp_relay enable dhcp_relay disable dhcp_relay Parameters {hops | time } [enable | disable] [enable | disable] [replace | drop | keep] {ipif } Each command is listed in detail in the following sections. config dhcp_relay Purpose Syntax Description Parameters Restrictions Used to configure the DHCP/BOOTP relay feature of the switch. config dhcp_relay {hops | time } This command is used to configure the DHCP/BOOTP relay feature. hops - Specifies the maximum number of relay agent hops that the DHCP packets can cross. time - If this time is exceeded, the Switch will relay the DHCP packet. Only Administrator or Operator-level users can issue this command. Example usage: To config DHCP relay: DES-3800:admin#config dhcp_relay hops 2 time 23 Command: config dhcp_relay hops 2 time 23 Success. DES-3800:admin# 314