D-Link DES-3828 Product Manual - Page 332

xStack DES-3800 Series Layer 3 Stackable Fast Ethernet Managed Switch CLI Manual enable address_binding acl_mode Purpose Syntax Description Parameters Restrictions Used to enable the ACL mode for an IP-MAC binding entry. enable address_binding acl_mode This command, along with the disable address_binding acl_mode will enable and disable the ACL mode for IP-MAC binding on the Switch, without altering previously set configurations. When enabled, the Switch will automatically create two ACL packet content mask entries that can be viewed using the show access_profile command. These two ACL entries will aid the user in processing certain IP-MAC binding entries created. None. Only Administrator or Operator-level users can issue this command. The ACL entries created when this command is enabled, can only be automatically installed if the Access Profile table has two entries available of the possible 9 entries allowed. These access profile entries can only be deleted using the disable address_binding acl_mode and NOT though the delete access_profile profile_id command. Also, the show config command will not display the commands for creating the IP-MAC ACL mode access profile entries. Example usage: To enable IP-MAC Binding ACL mode on the Switch: DES-3800:admin#enable address_binding acl_mode Command: enable address_binding acl_mode Success. DES-3800:admin# disable address_binding acl_mode Purpose Syntax Description Parameters Restrictions Used to disable the ACL mode for an IP-MAC binding entry. disable address_binding acl_mode This command, along with the enable address_binding acl_mode will enable and disable the ACL mode for IP-MAC binding on the Switch, without altering previously set configurations. When disabled, the Switch will automatically delete two previously created ACL packet content mask entries that can be viewed using the show access_profile command. None. Only Administrator or Operator-level users can issue this command. The ACL entries created when this command is enabled, can only be automatically installed if the Access Profile table has two entries available of the possible 9 entries allowed. These access profile entries can only be deleted using the disable address_binding acl_mode and NOT though the delete access_profile profile_id command. Also, the show config command will not display the commands for creating the IP-MAC ACL mode access profile entries. Example usage: To disable IP-MAC Binding ACL mode on the Switch: 328