D-Link DES-3828 Product Manual - Page 390
create pim crp, delete pim crp group <ip_addr/netmask>
UPC - 790069276811
View all D-Link DES-3828 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 390 highlights
xStack DES-3800 Series Layer 3 Stackable Fast Ethernet Managed Switch CLI Manual NOTE: The Probe time value must be less than half of the Register Suppression Time value. If not, the administrator will be presented with a Fail message. create pim crp Purpose Syntax Description Parameters Restrictions To enable the Switch to become a candidate to be the Rendezvous Point (RP). create pim crp group rp This command will set the parameters for the switch to become a candidate RP. This command is for PIM-SM configurations only. group - Enter the multicast group address for this switch to become a Candidate RP. This address must be a class D address. rp - Enter the name of the PIM-SM enabled interface the switch administrator wishes to become the CRP for this group. Only Administrator or Operator-level users can issue this command. Usage example: To create an IP interface to become a Candidate RP on the Switch: DES-3800:admin#create pim crp group 231.0.0.1/32 rp Trinity Command: create pim crp group 231.0.0.1/32 rp Trinity Success. DES-3800:admin# delete pim crp Purpose Syntax Description Parameters Restrictions To disable the Switch in becoming a possible candidate to be the Rendezvous Point (RP). delete pim crp group This command remove the switch's status of Candidate RP. This command is for PIM-SM configurations only. group - Enter the multicast group address for this switch to be removed from being a Candidate RP. This address must be a class D address. Only Administrator-level users can issue this command. Usage example: To delete an IP interface from becoming a Candidate RP on the Switch: DES-3800:admin#delete pim crp group 231.0.0.1/32 Command: delete pim crp group 231.0.0.1/32 Success. DES-3800:admin# 386